Caterpillar Inc.

Jason Mark Buckmier

Luke Edward Graham

Joshua D Callaway

Todd R Farmer

Steven James Juricak

Gregory August Epplin

Korby A Koch

Brian Franklin Taggart

Daniel A Cockman

Gilles Hoessler

Richard Ryan Evenson

David L Messer

W Ryan Most

Systems and methods for simulating electro-hydraulic (EH) braking of a work machine using a combination of hydraulic braking and engine braking may include determining a commanded brake pressure requested by an operator, determining an available engine braking force, and comparing the available engine braking force to a maximum available bleed pressure that is available to reduce a hydraulic braking force. An engine braking output and a pressure reducing valve output pressure may be determined based on the available engine braking force and the maximum available bleed pressure. A pressure reducing valve may be actuated so that the hydraulic braking force is equal to the commanded brake pressure minus the pressure reducing valve output pressure, and a transmission may be actuated so that the engine applies an engine braking force equivalent to the engine braking output to brake the work machine.

Simulated EH braking system and safety protection

A track type tractor incorporates control over lift, tilt, angle and pitch into an implement control joystick. The pitch cylinder and the tilt cylinder share segments of the hydraulic circuit, and a diverter valve prioritizes pitch control over tilt control in the rare occurrence when the operator is requesting both tilt and pitch changes to the dozer blade. Angle control and pitch control may be accomplished by finger controllers incorporated into the implement control joystick. Thus, the operator can control the dozer blade in four degrees of freedom without losing contact with the implement control joystick.

Machine with four degrees of freedom implement control joystick and track type tractor using same

An apparatus and method for controlling a work tool on a work machine are provided. The work machine may have first and second actuators, each actuator being operable in a vibratory mode and a non-vibratory mode, and each actuator being coupled to the work tool for changing the position of the work tool. The method may include simultaneously (i) operating the first actuator in a vibratory mode, (ii) operating the second actuator in a vibratory mode, and (iii) receiving a command to change the position of the work tool. The method may further include operating the first actuator in a non-vibratory mode to change the position of the work tool while operating the second actuator in a vibratory mode to vibrate the work tool, in response to receiving the command.

Apparatus and method for controlling work tool vibration

Growing community of inventors

Cary, NC, United States of America

Jason Mark Buckmier