The Watt Stopper, Inc.

Jason H Joyce

Louia Weidman

Peter John Horton

Eric J Fournier

Thomas L Grey

Jon Null

The methods and apparatus described enable automatic configuration, or commissioning, of controller devices and load control devices through a low voltage communication network controlled by one or more controller devices. These methods and apparatus further enable expansion of the load control system by connection of additional loads and or load control devices and or controller devices which will reinitialize the low voltage communication network and automatically reconfigure the controller devices and load control devices connected to the network.

Method and apparatus for electrical load control network

An occupancy sensor with integral light level sensors is configured to turn off or disable peripheral circuits and go into a periodic deep sleep mode to reduce phantom loading. Peripheral circuits include occupancy sensor circuits and relay drive circuits, but may include other circuits such as communication circuits. The sensor may be configured to periodically wake itself up, check ambient light conditions to see if lighting is below the set threshold. If it is not, the sensor goes back to sleep. If it is, then the sensor can power up the occupancy sensor circuit to see if the space is occupied; if not, it can go back to sleep. If the space is occupied, it can turn on other peripheral circuits necessary to control the load.

Method and apparatus for controlling light levels to save energy

An active ultrasonic room occupancy sensor with the output amplitude of the transmitter controlled by the amplitude of power applied to the transmitter to control the zone of coverage for a sensor. An adjustable voltage regulator under control of a microcontroller applies controlled amplitude voltage to the transmitter to adjust the output amplitude of the transmitter. The adjustable amplitude transmitter allows an occupancy sensor to have its total output energy adjusted to conform to the area to be covered. Lowering the total ultrasonic energy in the monitored space lowers the sensitivity of the receiver to inappropriate activations. Lowering the input power to the transmitter also lowers the total internal system noise and provides an improved signal to noise ratio in the receiver. Alternatively, the power applied to the receiver may also be controlled by an adjustable voltage regulator under control of the microcontroller to improve receiver efficiency.

Growing community of inventors

Carlsbad, CA, United States of America

Jason H Joyce