Ford Global Technolgoies, LLC

James Wright

Peter Brittle

Paspuleti Ashish Kumar Naidu

Ian Halleron

Ashish Kumar Naidu

Jim Bromham

Kim Ford

Matthew Mitchell

Steve Johnson

Peter George Brittle

Jan Harmsen

David Jonathan Brook

A system and method for providing torque-assist to a rotary shaft of an internal combustion engine control an electric machine in response to operation of an exhaust gas recirculation (EGR) valve to assist the rotation of the rotary shaft. The system and method facilitate periodic operation of the EGR valve to purge condensation without objectionable torque reduction when the engine is operating near full load.

Method and system for providing torque-assist

A system and method for increasing engine heating rate to facilitate early introduction of exhaust gas recirculation after a cold start include operating an electric machine connect to the engine to apply a load to the engine. The electric machine may be operated as a generator to produce an increased engine torque demand and increase the rate of engine heating until an engine temperature and an exhaust temperature exceed corresponding thresholds. Operation of the electric machine as a generator may be stopped in response to a battery state of charge exceeding a threshold, or engine load exceeding a threshold.

Method of reducing engine NOx emissions

An exemplary method of providing torque-assist to a crankshaft of an internal combustion engine includes, among other things, assisting a rotation of the crankshaft using an electric machine during the transition between stages of a multi-stage forced induction system.

Method and system to provide engine torque

A method for preventing overheating of a diesel particulate filter during regeneration when an engine is idling may include using an electric machine to apply a load to the engine and compensating for the increase in applied load by increasing an engine torque set point to reduce the concentration of Oxygen in the exhaust gas flowing to the diesel particulate filter. Increased engine torque may be provided by adjusting air-fuel ratio by enriching an air-fuel mixture supplied to the engine and the diesel particulate filter. The control may be initiated in response to entering an idle mode during regeneration or in response to a measured or estimated temperature of the diesel particular filter exceeding a threshold or limit. Estimated temperature may be predicted using a soot combustion model.

Method of protecting a diesel particulate filter from overheating

A method of removing sulfur from a lean NOx trap of a mild hybrid vehicle while the vehicle is stationary is disclosed, the method comprising connecting an electrical system of the vehicle to a large capacity external battery, operating an integrated starter generator driven by an engine of the vehicle as a generator to load the engine thereby allowing the engine to be operated at a higher torque level and rich of stoichiometric and storing the electrical energy produced by the integrated starter generator in the large capacity battery during the time period required for the removal of sulfur from the lean NOx trap.

Method and system for removing sulfur from a lean NOx trap

A method for predicting the future operation of a vehicle is disclosed which uses stored data representative of commonly followed routes to predict the future operation of the vehicle for the current trip. By establishing that the route currently being followed is comparable to one of the commonly followed routes, information relating to that 'common route' is then used to predict the future operation of the vehicle for the current trip.

Growing community of inventors

London, United Kingdom

James Wright