Eaton Corporation

James R Hanna

James Leo Lagree

Todd Matthew Lathrop

Ronald Dale Hartzel

Bert Popovich

Derrick G Berad

James W McGill

A control system for a power distribution system includes electrical operators each of which has an open input, a close input and an operator member adapted to cooperate with a corresponding circuit breaker operating mechanism. Each operator member responds to the corresponding open input to actuate the operating mechanism and open the corresponding circuit breaker, and responds to the corresponding close input to actuate the operating mechanism and close the corresponding circuit breaker. A control circuit includes an input for a normal power source, an input for an emergency power source, open outputs electrically connected to the open inputs of the corresponding electrical operators, and close outputs electrically connected to the close inputs of the corresponding electrical operator. The control circuit delays one or more of the close outputs or inhibits one or more of the close outputs after a transfer switch output switches to the emergency source.

Power distribution system and control system for same

A control circuit operates a dual directional DC motor from an AC power source. A controller has first and second position indication inputs adapted to receive respective first and second position indications. The controller also has first and second direction outputs, which respectively energize one of two first relay coils having contacts outputting respective AC voltages responsive to the direction outputs. A full wave bridge rectifier receives the AC voltage and responsively outputs a DC voltage, which energizes a second relay coil. A contact thereof directs that voltage to two sets of first relay contacts, which are also responsive to the direction outputs, and which respectively provide a positive or negative DC voltage to the motor. Another second relay coil contact provides a braking action to the motor responsive to removal of the DC voltage from the rectifier output following removal of the AC voltage to the rectifier.

Control circuit for a dual directional direct current motor employing a single alternating current power source

A transfer switch system includes a controller which sends separately timed restart signals over a communications network to an addressable relay associated with each load in order to sequentially restart the loads following a transfer. When the loads are elevators, the controller sends a prepare to transfer signal to each elevator through the associated addressable relay directing the elevator to park at a floor with its doors open and delays making a discretionary transfer until all elevators send a reply message over the network that they are appropriately parked. A message from the utility directing a reduction in use of their power can be sent to the controller over the communications network through an additional remote station. The controller can then transfer to the alternate power source and/or send messages to selected loads to shut down.

Transfer switch system with subnetwork

Transfer between alternative electrical power sources for highly inductive loads, such as motors, is made using an open transition with the load connected to the new source only after the voltage on the load bus has fallen below a predetermined value, preferably a value which is about 30% or less of the nominal source voltage.

Growing community of inventors

Beaver, PA, United States of America

James R Hanna