United Technologies Corporation

Atlantic Richfield Company

Continental Can Company, Inc.

James G Morris

Franklin D Lemkey

Gunther Scharf

Subodh K Das

Harish D Merchant

Lian Chen

Methods for the improvement of mechanical properties of aluminum can stock materials. In one method, an aluminum alloy is cast into an ingot, heated at an elevated temperature to homogenize the alloy, hot rolled at an elevated temperature to form hot band material and cold rolled to final gauge. After the heating step, the alloy is hot rolled immediately to minimize the cooling of the alloy between the heating and hot rolling steps.

Method of forming aluminum alloy sheet

Non-galling, low earing can stock suitable for deep drawing and wall-ironing into can bodies is prepared from continuously cast aluminum alloy strip of an inch or less in thickness. The strip material is heated to a temperature of from 950.degree. to 1150.degree. F. for a time sufficient to homogenize the alloy. The homogenized strip material is cold rolled to effect a first reduction in sheet thickness of at least 25%. The cold rolled sheet is heated to a recovery temperature of up to about 550.degree. F., and subjected to a second cold rolling to effect a reduction in thickness of up to 50%. The cold rolled sheet product is heated to the recrystallization temperature and then subjected to effect a final reduction in thickness of at least 50% of the original thickness of the sheet to impart an H19 temper to the sheet.

Process for the manufacture of continuous strip cast aluminum alloy

A high ductility, high strength, moderate conductivity aluminum conductor article and process for making the article are described. The article is a conductor of elongated geometry containing a low volume fraction of intermetallic fibers which are aligned parallel with the major axis of the conductor. The surrounding matrix is aluminum of at least commercial purity to which from 0.5 to 1.5% copper has been added. The fabrication process involves the coupled solidification of eutectic and slightly proeutectic compositions to produce a fibrous microstructure, followed by mechanical working. The ductility of the finished article will exceed about 5%. The final properties may be varied by heat treatments. The broad composition is 1.0-2.0% Co, 0.5-1.5% Cu, balance aluminum.

High ductility, high strength aluminum conductor

Growing community of inventors

Lexington, KY, United States of America

James G Morris