National Semiconductor Corporation

Idexx Laboratories, Inc.

James Edward Milan

Garland Christian Misener

Robert W Lachapelle

A method of normalizing an analyzer response value of a fluorescence analyzer is provided. The method includes measuring an excitation spectrum of the analyzer and measuring an emission sensitivity spectrum of the analyzer. Next, a normalization factor based at least in part upon the excitation spectrum of the analyzer and the emission sensitivity spectrum of the analyzer is determined. The sample is then analyzed to obtain an uncorrected analyzer response value. A normalized analyzer response value is calculated based at least in part upon the uncorrected analyzer response value and the normalization factor.

Method of normalizing a fluorescence analyzer

An electrical connector (10) provides a mechanical coupling and an electrical interface between circuit boards (12,14). An elastomeric electrical conductor (20) provides compressible electrical connector paths between first and second sets of electrical contact pads (28,15) coupled to the respective circuit boards. A compression mounting assembly (22) aligns and retains the elastomeric electrical conductor (20) between the sets of electrical contact pads. The elastomeric electrical conductor (20) affords relatively high frequency signal conducting paths with substantially constant impedance for example for passing test signals and pin signals without distortion between circuit boards in the test head of an IC device tester. A mechanical spring system (64,65) spring loads the compression mounting assembly (22) and provides a relatively high mechanical compliance coupling between circuit boards (12,14) to accommodate relative change of position of the boards due to misalignment or board warpage. The electrical connector (10) is used for example between the pin electronics cards (12) and the IC device under test loadboard (14) in the test head of IC device testers for testing high speed ECL devices.

Growing community of inventors

Buxton, ME, United States of America

James Edward Milan