Hitachi, Ltd.

Other

Hitachi Car Engineering Co., Ltd.

Ichiro Ohsaka

Kaneyuki Okamoto

Tatsuya Yoshida

Hiroyuki Saito

Shinichi Sakamoto

Mitsuhiko Watanabe

Kiyoshi Horibe

Yuichi Kuramochi

Junji Shiokawa

Shoji Sasaki

Hiroshi Chiba

Katsuya Oyama

Toshio Murakami

Takashi Azumi

Yoshihiro Todaka

Toshio Hayashibara

Mitsuru Kon'i

Mitsuru Kon'l

Mitsuru Kon-i

An electric power supply system for a vehicle has an electric power line wired in a loop configuration. From the electric power line power is supplied to a load, and to another system which supplies control system power supply. One shutdown circuit is provided in a module connected to the loop configured power supply line. When the electric power line and the load are short circuited, the shutdown can isolate and shut down only the failure point. Further, when the car is not in use, by stopping the power supply to the load, current consumption can be restrained. In response to detection of a ground short and a failure of a connection of a connector, an over-current prevention of an electric power line, a simple construction can be provided and a low current consumption can be realized.

Power supplying apparatus for vehicle and intensive wiring apparatus

A control apparatus for controlling multiple power loads in a vehicle includes a circuit for detecting a current abnormality of a power element and a circuit for monitoring a temperature abnormality in a locality of the power element. Circuits are also provided continuing or shutting down the power element based on information concerning the above stated current and/or temperature abnormalities, with a timing which is established according to a substantially constant period or a time interval which is stored in advance in a memory element.

Apparatus with an over-current shutdown means and an over-temperature shutdown means

In an electric power switch circuit with an overcurrent or overheating protection function, unnecessary ON-OFF cycling is prevented. A MOSFET is used as an electric power element for energizing a load according to a control signal. A temperature detector detects the temperature in the neighborhood of the MOSFET, and a control unit opens a switch, interrupting input of the control signal to the MOSPET when the temperature detected by the temperature detecting means is higher than the predetermined temperature. An interruption status retaining device maintains the interruption of the control signal, preventing repetitive ON-OFF cycling.

Switch circuit having protection function to interrupt input of control signal

A video camera has a memory for storing the position of an image lens in relation to the position of a variator lens, that is, zoom tracing curves in respect of individual subject distances, a motor for moving the image lens while vibrating it slightly during zooming operation, a variation component extractor circuit for extracting the amplitude and phase of a slight variation component of focusing voltage generated by moving the image lens while vibrating it slightly, and a controller for controlling drive means on the basis of the stored zoom tracing curves and an extracted slight variation component. During zooming operation, the controller first controls the motor in compliance with a position of the variator lens pursuant to a zoom tracing curve stored in the memory in association with a position assumed by the image lens immediately before start of the zooming operation. The controller also operates to correct a drive amount of the image lens on the basis of amplitude of an extracted slight variation component and when the amplitude of the slight variation component falls below a predetermined value, the controller controls the motor pursuant to a newly determined zoom tracing curve.

Video camera with autofocus function and method of controlling the same

Growing community of inventors

Kawasaki, Japan

Ichiro Ohsaka