Cisco Technology, Inc.

Hrishikesh Vishwas Kulkarni

Balaji Lakshmikanth Bangolae

Amit S Phadnis

Sudhakar Shenoy

Pankaj Vyas

Srinivas Ananthanaga Kuruganti

Tak Ming Francis Pang

Shoou Jiah Yiu

Jagadeesh Maiya

Krishnakumar Ramachandran

Raghavendra Gopinath

M A Sheik Farid

A mesh network includes a controller, root access points (APs), and mesh APs assigned to different groups of APs. The controller creates for each group a distinct subset channel list of backhaul channels used by root APs of the group that are connected to the controller. The controller updates, for each group, the subset channel list as root APs assigned to the group connect with and disconnect from the controller. The controller sends, for each group, the subset channel list to the mesh APs assigned to the group that are connected with the controller through respective root APs when the subset channel list is created and updated.

Techniques to create, update, disseminate, and use dynamic subset backhaul channel lists in a mesh network

To send a connection control message associated with a first set of attributes, only a difference of the first set of attributes from a second set of attributes associated with an already active virtual circuit (to a common destination) may be sent (contained in the connection control message). The devices receiving the message may create the necessary configuration for the new virtual circuit by modifying a copy of the configuration of the active virtual circuit. Processing requirements may be minimized as the devices may not need to parse and decode long list of information element. The feature may be particularly important in setting up a virtual circuit for voice calls, as a long list of attributes may be associated with each virtual circuit, but the difference of attributes being only minimal.

Efficient processing of connection control messages in managing virtual circuits using signaling protocols

The bandwidth of a virtual circuit is changed when the aggregate bandwidth available on path(s) to an adjacent ATM device (through which the VC is provided) changes. The change of bandwidth may be implemented by changing the QoS parameters associated with the virtual circuits. Thus, for example, when one of the paths becomes non-operational, the bandwidth of a virtual circuit may be reduced in a fair manner.

Managing the bandwidths of virtual circuits when the aggregate bandwidth to an adjacent device changes

Moving a virtual circuit from one port interface to another when multiple port interfaces are present between two network devices. Such a move may be performed, for example, when a port interface fails or when needed to balance the load (e.g., aggregate amount of bandwidth of all virtual circuits presently assigned to a port interface) across multiple port interfaces. As a result, the port interfaces may be used efficiently.

Efficient use of multiple port interfaces available on a network device supporting ATM

The services offered (e.g., bandwidth) by a PVC can be changed, potentially as and when desired. An end system (of a PVC) may send a request to initiate a change of a service. Each intermediate system may first determine whether the service change can be supported, and passes the request to the next system in the path until the request is received by the other end system of the PVC. Assuming the other end system also can support the change, an acceptance response is propagated in the reverse direction of the same path. Each system may effect the service change upon receiving the acceptance response.

Growing community of inventors

Bengaluru, India

Hrishikesh Vishwas Kulkarni