Cisco Technology, Inc.

Hongshin Jun

William Eklow

Sung Soo Chung

Gyaneshwar S Saharia

Sang Hyeon Baeg

Sun-Gyu Kim

A method to perform component testing by supplying test patterns to a serial input pin coupled to an IEEE 1149.6 boundary-scan cell that is associated with an IEEE 1149.6 test receiver. The test receiver is configured to operate in a scan test mode. The output from the test receiver circuit is coupled to a logic block to be scan tested. The output from the logic block is coupled to a serial output pin on the integrated circuit during scan test mode. High performance integrated circuits can use SerDes pins in a scan test mode to be scan tested without impacting mission critical signals.

Removing scan channel limitation on semiconductor devices

Disclosed are, inter alia, methods, apparatus, data structures, computer-readable media, mechanisms, and means for providing a JTAG to system bus interface for accessing embedded analysis system(s). JTAG commands are received and converted into commands sent out a bus to a device including an embedded analysis instrument, with results received over the bus forwarded out the JTAG interface to an external device. Such a JTAG to system bus interface may eliminate the need to provide separate JTAG TAP interfaces on each ASIC of a board, and/or eliminate the need to daisy chain multiple TAP interfaces of multiple ASICs in order to provide a single TAP interface for accessing the multiple embedded testing instruments.

JTAG to system bus interface for accessing embedded analysis instruments

Programmable test pattern driver and capture mechanisms for boundary scan cluster or functional block testing. A boundary scan test system includes at least one device under test. The device may include a Test Access Port (TAP) controller, a plurality of output AC boundary scan cells (BSCs), and a plurality of input AC BSCs. The device may further include a programmable AC_Pattern_Source signal generator configured to produce AC signal patterns that selectively remain unchanged for at least one cycle before and after an original capture cycle location, a programmable AC_Sync signal generator configured to independently control the AC_Sync signal to lead or lag an original cycle location at full cycle increments, a programmable phase controller configured to independently control either the rising or falling edge aligned AC_Pattern_Clock signal or AC_Counter_Clock signal, and an AC_Test_Clock signal switcher configured to selectively utilize one of a plurality of clock signals including a TCK signal.

Growing community of inventors

San Jose, CA, United States of America

Hongshin Jun