Toho Tenax Co., Ltd.

Hiroshi Kimura

Taro Oyama

Hidekazu Yoshikawa

Rie Kawahito

There is disclosed a method of producing a pre-oxidation fiber in the production of the pre-oxidation fiber by subjecting a polyacrylic precursor fiber to pre-oxidation processing in an oxidizing atmosphere, including shrinking the precursor fiber as a pretreatment of pre-oxidation at a load of 0.58 g/tex or less in the temperature range of 220 to 260&#xb0; C. under conditions in which the degree of cyclization (I/I) of the precursor fiber measured by a Fourier transform infrared spectrophotometer (FT-IR) does not exceed 7%, initially-drawing the precursor fiber at a load of 2.7 to 3.5 g/tex in an oxidizing atmosphere at 230 to 260&#xb0; C. in the ranges of the degree of cyclization of not exceeding 27% and of the density of not exceeding 1.2 g/cm, and then subjecting the pre-oxidation fiber to pre-oxidation treatment. A carbon fiber of high strength and high elasticity that is appropriate for composite materials that exhibit high composite performance is obtained by continuously subjecting this pre-oxidation fiber to carbonization treatment.

Method of producing pre-oxidation fiber and carbon fiber

A carbon fiber strand obtained by bundling 20,000-30,000 carbon fibers each having, in the surface thereof, creases which are parallel to the fiber-axis direction. In an examination with a scanning probe microscope, the creases in the carbon fiber surface are apart from each other at a distance of 120-160 nm and have a depth of 12-23 nm, excluding 23 nm. The carbon fibers have an average fiber diameter of 4.5-6.5 nm, specific surface area of 0.9-2.3 m/g, and density of 1.76 g/cmor higher. The carbon strand has a tensile strength of 5,900 MPa or higher and a tensile modulus of 300 GPa or higher. When would on a bobbin at a tension of 9.8 N, the strand on the bobbin has a width of 5.5 mm or larger. When the carbon fiber strand is examined by a strand splitting evaluation method in which the strand is caused to run through three stainless-steel rods while applying a tension of 9.8 N thereto, no strand splitting is observed.

Carbon fiber strand and process for producing the same

A carbon fiber strand which is produced by obtaining a solidified-yarn strand by spinning with a spinneret having 20,000-30,000 spinning holes, passing the strand through an interlacing nozzle having an air blowing pressure of 20-60 kPa to obtain precursor fibers, oxidizing them in heated air having a temperature of 200-280&#xb0; C. to obtain oxidized fibers, subjecting these oxidized fibers to a first carbonization treatment in an inert-gas atmosphere at a temperature of 300-900&#xb0; C. in which the fibers are firstly stretched in a stretch ratio of 1.03-1.06 and then secondarily stretched in a stretch ratio of 0.9-1.01, subsequently conducting a second carbonization treatment in an inert-gas atmosphere at 1,360-2,100&#xb0; C., and then conducting a surface oxidization treatment in an aqueous solution of an inorganic acid salt in a quantity of electricity of 20-100 C per g of the carbon fibers. This carbon fiber strand has a strand tensile strength of 5,650 MPa or higher, strand tensile modulus of 300 GPa or higher, and strand width of 5.5 mm or larger. No strand crack is observed in an examination by a strand crack evaluation method.

Growing community of inventors

Shizuoka, Japan

Hiroshi Kimura