Hitachi, Ltd.

Hitachi Automotive Systems, Ltd.

Hiromu Kakuya

Shiro Yamaoka

Kengo Kumano

Atsushi Shimada

Shinji Nakagawa

Kunihiko Suzuki

Shinya Satou

Toshimichi Minowa

Shinya Sato

Motoo Futami

Yoshihiro Sukegawa

Tohru Kohno

Mamoru Nemoto

Norihito Kobata

Souichiro Kiyoki

In a case in which a local solution to current-voltage characteristics is generated by way of a partial shade, it has been difficult to perform control for causing a solar cell to operate at a maximum power point efficiently in terms of power and at a low cost. During steady state operation, an MPPT control unitfor performing the normal hill climbing method is selected, and if the change amount of the output current of the solar cell is greater than or equal to a predetermined threshold, an MPPT control unitfor increasing the variation width of the output voltage of the solar cell to greater than the hill climbing method is selected. By way of such control, it is possible to achieve both efficient operation in a steady state and avoidance of a local solution to a partial shade at a low cost.

Solar power system and control system

An object is to provide a control device and control method for a compressed self-ignition type internal combustion engine, which can reduce torque variation due to misfire when the air-fuel ratio varies during compressed self-ignition type combustion, and thereby effectively use the potential for reducing fuel consumption. As the combustion mode, a spark-ignition type combustion mode by use of an ignition plug and a compressed self-ignition type combustion mode which utilizes a pressure increase in a combustion chamber in association with upward movement of piston are selectively set depending on an operational state of the engine, and when the air-fuel ratio in the compressed self-ignition type combustion mode is rich, a regional upper limit of the compressed self-ignition type combustion region is changed toward the lower engine torque side, and when the air-fuel ratio is lean, the regional upper limit is changed toward the higher engine torque side.

Control device for compressed self-ignition type internal combustion engine

Disclosed herein is a control apparatus for a spark-ignition engine that is capable of avoiding knocking at the time of high-load operation. With this control apparatus, a residual-gas suction unit or the like is not used, an exhaust gas does not deteriorate due to injection in a compression stroke, and a thermal efficiency also does not decrease. An engine control apparatus (ECU)is used for the control of a direct-injection type spark-ignition engine. During the high-load operation of the spark-ignition engine, the ECUinjects fuel a plurality of times. In addition, the ECU performs first fuel injection toward internal EGR that exists in a combustion chamber of the spark-ignition engine.

Control apparatus for spark-ignition engine

An engine controller capable of reducing torque fluctuation and the like in change between spark ignition combustion and homogeneous charge compression ignition combustion is provided. Spark ignition burning mode or homogeneous charge compression ignition burning mode is selectively set as burning mode according to the operating state of an engine. In spark ignition burning mode, a spark plug is used. In homogeneous charge compression ignition burning mode, fuel is burned utilizing pressure rise in a combustion chamber in conjunction with the ascent of a piston. The burning mode is changed between these modes. In transition for change between the spark ignition burning mode and the homogeneous charge compression ignition burning mode, the following measure is taken: a period during which the lift amount and/or the valve opening period (IVevent) of an intake valve is made smaller than a set value for the homogeneous charge compression ignition burning mode is provided.

Apparatus and method for controlling engine

A first, a second, and a third combustion region are defined by the air-fuel ratio of the mixture gas feeding combustion. Upon switching of combustion regions from the first combustion region to the third combustion region and from the third combustion region to the first combustion region, namely, when the second combustion region is passed, the mass of NOx emission downstream of an exhaust purifying device and the torque variation are estimated online. Based on the estimated value of the mass of NOx emission and the estimated value of the torque variation, the mass of intake air introduced into the combustion chamber is adjusted in a manner different from when normal, such as by changing the amount of lift of the intake valve, for example, so as to reduce the mass of NOx emission downstream of the exhaust purifying device and the torque variation below predetermined values upon passing of the second combustion region. Thus, the increase in exhaust emissions and the deterioration of operability during the switching of combustion regions can be suppressed.

Engine controller

In an engine controller capable of carrying out spark ignition type combustion and compressed self-ignition type combustion, in order to suppress operation performance deterioration and exhaust performance deterioration at the time of switching a combustion mode from the compressed self-ignition type combustion to the spark ignition type combustion, intake pipe pressure downstream a throttle is quickly reduced by making the throttle opening degree smaller than a target throttle opening degree of the spark ignition type combustion immediately after switching for a certain period during the combustion mode is switched from the compressed self-ignition type combustion to the spark ignition type combustion. As a result, responsiveness of an intake amount at the time of switching the combustion mode from the compressed self-ignition type combustion to the spark ignition type combustion is enhanced, and combustion switching without exhaust deterioration and torque variation is realized.

A controller of an internal combustion engine capable of spark ignition combustion and compression ignition combustion which restrains the degradation of operation performance and exhaust performance at the time of combustion type switching. The controller includes control means for performing combined combustion which leads to ignition combustion by a pressure rise by spark ignition combustion through adjustment of an internal cylinder temperature and a combustion speed at the end of compression, wherein the combined combustion is performed in the process of combustion type switching between spark ignition combustion and compression ignition combustion based on a result of determination of whether or not combustion type switching is possible, thus implementing a smooth combustion type switching.

Controller of internal combustion engine of compression ignition combustion type

In a homogeneous charge compression-ignited internal-combustion engine, based on information regarding the operational state of the engine, a combustion mode switching discriminator selects a homogeneous charge compression-ignited combustion mode if engine operating conditions allow homogeneous charge compression-ignited combustion. If not, the combustion mode switching discriminator selects a spark-ignited combustion mode. Immediately after switching from spark-ignited combustion to homogeneous charge compression-ignited combustion, a combustion mode switching corrector outputs switching correction values for operating quantities for homogeneous charge compression-ignited combustion. The correction values are used to adjust the operating quantities for homogeneous charge compression-ignited combustion, and new operating quantities obtained from the adjustments are output as control quantities from a combustion mode selector.

Apparatus and method for controlling a homogeneous charge compression-ignited internal-combustion engine

When a throttle is fully open, a maximum torque set value is corrected based on the ratio between the maximum air volume set value under fully-open throttle conditions and the actual maximum air volume detected by an intake air volume meter such as an air flow sensor. Based on the corrected maximum torque set value, both the relation between the degree of accelerator opening and target torque and the relation between the target torque (target air volume) and the degree target throttle opening are corrected. Thus, even when various types of disturbances relating to torque error are generated, such as variations in air density generated in association with variations in temperature or altitude, variations over time such as contaminations of throttle chambers, or difference between machines such as engine bodies or auxiliary machines, it is possible to generate actual torque with respect to a target torque with a high degree of accuracy, while maintaining a desired relation between the degree of accelerator opening and the throttle opening.

Engine controller and controlling method

A control apparatus of an engine having a compression ignition combustion mode and a spark ignition combustion mode selects the spark ignition combustion mode when operation conditions fall within a spark ignition operation area set in a spark ignition operation area/compression ignition operation area setting map memory part and selects the compression ignition combustion mode when the operation conditions fall within a switching stable area set in the memory part upon operation by the spark ignition combustion mode. The control apparatus controls to continue the compression ignition combustion mode as long as the operation conditions fall within a compression ignition operation area set in the memory part upon operation by the compression ignition combustion mode.

Apparatus and method for controlling internal combustion engine

An engine controller controls an actuator for selectively executing spark-ignited combustion and compression-ignited combustion of an internal combustion engine in accordance with an engine operational state. The controller is comprises of a deterioration recognition section for recognizing a deterioration state of the engine or the actuator during the spark-ignited combustion. The engine controller is configured to change at least one of a switching condition between the spark-ignited combustion and compression-ignited combustion and an operational condition for the compression-ignited combustion, during the spark-ignited combustion, in accordance with the deterioration state of the engine or the actuator recognized by the deterioration recognition section.

The controller includes combustion mode switching means for decreasing an exhaust gas temperature in the spark ignition combustion immediately before the combustion mode switching based on an estimated exhaust gas temperature immediately before the combustion mode switching, or for decreasing an EGR amount in the HCCI combustion immediately after the combustion mode switching.

Controller for compression ignition engine

There is provided an engine control unit to ensure operational performance and safety performance of a vehicle by carrying out switchover of combustion according to an operating condition of a vehicle (automobile). A vehicle peripheral condition such as vehicular gap, etc., a traveling geographical state, a condition that ensures vehicle stability, etc. are acquired, and switchover of combustion, for example, switchover between compression ignition combustion and spark ignition combustion is effected correspondingly.

Growing community of inventors

Hitachinaka, Japan

Hiromu Kakuya