Hoesch Werke Aktiengesellschaft

Hans J Wahl

Rolf Krebs

Karl-Heinz Schlusnus

Peter Schorr

Wilfried Kliesch

Heinz Strauch

Paul Krenzer

Franz-Josef Peters

Friedrich O Koch

It is necessary to determine welding temperature as precisely as possible in order to properly control the high-frequency welding of longitudinal pipes. Changes in welding temperature are proportional to alterations in the welding current that flows through the edges of the skelp. Magnetic-field sensors can be used to directly and precisely determine alterations in the current and hence changes in the temperature. Voltages induced in the sensors can be processed into setting signals to correct the high-frequency welding generator and disruptions in the current used to generate signals to mark the site of failure on the pipe for subsequent rejection.

Method of and device for monitoring and/or controlling welding current

An arrangement for automatically tracking systems to the center of weld gaps, weld joints or weld reinforcements, in which one or more electrically scanning probes receive signals reflected by a workpiece surface as long as this surface is substantially parallel to the acting surface of the probe. The signals breakdown spontaneously when the surface clearly deviates from the parallel as in the case with the flanks of gaps, joints or reinforcements. The breakdown of the signal is applied for storing an electrical value corresponding to the instantaneous probe position, the probe position for the left flank when traveling from left to right and for the right flank when traveling from right to left. The center of the gap, of the joint or of the reinforcement is computed from the stored electronic position values in a series-connected electronic device, by means of a computer circuit. The computer value is compared with an electrical value corresponding to the center position of the system, and in case there is a difference between the compared values, a corresponding control command is formed. The width of the gap, joint or reinforcement is determined electronically and compared with a given empirical value. The gradient of the seam center deviation may also be determined and compared with a given empirical value. The latter two comparisons are useful for increasing the reliability of operation of the tracking device.

Method and device for automatically tracking systems to the center of

Growing community of inventors

Munster, Germany

Hans J Wahl