U.S. Philips Corporation

Guy L De Bondt

Antonius A Marinus

Hubertus Cornelis Miermans

Patrick E Smeets

In a standby mode, a switched-mode power supply circuit may be operated in a burst mode with reduced secondary voltages (Vo1, Vo2) for supplying a standby voltage (Vo1) at a very high efficiency. In a normal operating mode of the power supply, a control circuit (1) is maintained in its on-state by a power supply voltage (Vcc) generated by the power supply. The control circuit (1) supplies control pulses (Vd) for switching the power supply. The burst mode is obtained by decreasing the power supply voltage (Vcc) generated for the control circuit (1) to such an extent that, without any further provisions, the control circuit (1) reaches an off-state in which no control pulses (Vd) are generated. In the standby mode, the control circuit (1) is supplied with current by a power supply circuit (4). In the off-state, the control circuit (1) takes up a smaller power supply current (Icc) from the power supply circuit (4) than it is supplying and the power supply voltage (Vcc) increases until the control circuit (1) reaches the on-state and starts generating the control pulses (Vd). In the on-state, the control circuit (1) takes up a larger current from the power supply circuit (4) than it is supplying and the power supply voltage (Vcc) decreases until the control circuit (1) reaches the off-state again. In this way, the power supply, in the standby mode is each time active during first periods and inactive during second periods. To bring the power supply voltage to the standby mode, the power supply voltage (Vcc) generated for the control circuit (1) is decreased in such a way that also the secondary voltage (Vs1, Vs2) are decreased.

Switched-mode power supply

A switched mode power supply circuit includes a controllable switch in series with an inductive element between the terminals of a DC input voltage. A control circuit renders the switch alternately conductive and non-conductive. A rectifier for deriving a DC output voltage is coupled to the inductive element. To prevent the inductive element from becoming saturated, a switching element is coupled to the control circuit for maintaining the controllable switch in its blocked state only during a time interval which immediately follows an interval of conductance of the controllable switch and during which the voltage across the inductive element has the same polarity as when the rectifier is conductive.

SMPS apparatus having a demagnetization circuit

A switched-mode power supply circuit having a transformer and a first controllable switch on the primary side of the transformer. A first section is in the form of a flyback d.c. converter including a first secondary winding of the transformer for generating a first d.c. output voltage which is stabilized, by a control, against d.c. input voltage variations of the circuit and of a first load. A second section including a second secondary winding of the transformer constitutes a forward d.c. converter having a second controllable switch for generating a second d.c. output voltage. The ratio between the period of conductance of the second switch and the period of the control signal of the first switch is independent of the frequency of this signal.

Growing community of inventors

Eindhoven, Netherlands

Guy L De Bondt