Dell USA L P

Dell Corporate Services Corporation

Dell Computer Corporation

Gregory N Stewart

Warren W Startup

John P Busch

Anthony L Overfield

N Albert Sato

Mark T Ellis

David R Lunsford

Christian G Okonsky

A portable computer in which a single switch is positioned to be closed when the case is closed, and also to be readily operable by the user's finger. Software polls the switch. If the switch is briefly depressed, the software detects that the user is requesting entry into standby mode, and accordingly powers down certain input/output functions until new stimulus is received. If the switch is held down for a long time by the user closing the case cover, or manually holding the button down for a long time, the software causes the system to enter sleep mode (its lowest power mode).

Portable computer with time-sensitive tri-modal power management switch

A portable computer system with a special connector, on the motherboard, into which a field-installable boot card can be inserted. The special motherboard connector is wired so that the operator, by setting connections on the field-installable boot card, can bypass the boot memory on the motherboard and force the computer to boot from the memory on the boot card. This permits a technician, in the field, to temporarily override the internal nonvolatile memory which holds the basic system software. This permits recovery of a system in which the basic system software has been corrupted. Preferably the motherboard boot memory is a flash EPROM, and can be rewritten, by setting appropriate jumpers on the boot card, after the computer has booted from the boot card. The motherboard connector is preferably located on the motherboard, and is accessible through a removable cover. This connector can also preferably be used for temporary attachment of a diagnostic display card.

Computer system with plug-in override of system ROM

A portable electronic system which includes a smart power-management controller. The power-management controller is programmable to vary its operational parameters (such as the time without input which will send the system into a standby mode). The power-management controller also has the capability to self-program at least some of these parameters: thus, for example, if a user repeatedly demands a system power-up soon after the system had been placed into standby mode, the inactivity period required for entering standby mode will be increased.

Portable computer system with adaptive power control parameters

A portable electronic system which has two electrically separate battery banks in a single removable battery pack. A power-management controller switches between the two banks in service--even when neither of the banks is exhausted--to provide optimal active and resting times for the batteries.

Rechargeable system with separate battery circuits in a common module

A portable computer system wherein the printer port can be used, at the user's option, not only for connection to a printer, but also for connection to an external floppy disk drive. If the BIOS determines that there is an external floppy drive attached, the BIOS disables the normal operation of the parallel port in order to allow the external floppy to operate.

Portable computer with automatic adaption to different device types on a

A system for controlling the rate and duration of battery charging. A microprocessor is connected in a battery current signal feedback loop and used to control the battery charge cycle. The rate of charge is gradually stepped up at the beginning of the charge cycle until the charging current reaches a defined maximum value, and thereafter maintained between the maximum and a defined minimum value for the duration of the charge cycle. The microcontroller terminates the charge cycle when the battery charging current begins to increase while the rate of charge remains constant, this being an indication that the battery is fully charged. Sensors input signals to the microcontroller to prevent or terminate charging if the battery cells are not within an appropriate temperature range, or if a short circuit or other adverse condition arises.

Charging system for battery powered devices

Method and apparatus for increasing the amount of power that may be extracted from a plurality of parallel connected battery banks by periodically effecting a switching between the banks for operative coupling to the power supply of an electronic or electrical device. The apparatus comprises at least two battery banks, a switching means, a microcontroller and a battery powered load. Upon each expiration of a predetermined time interval, the microcontroller monitors the voltage of the battery banks to determine which of the banks has the highest voltage. The microcontroller then positions the switch so that the bank with the highest voltage is coupled to the power supply of the load. In another embodiment, switching occurs upon a determination that the active bank has reached a specified power output.

Power management control system for battery powered devices

A system for automatically adapting the power conservation functions of a personal computer (PC) to the work patterns of any user. A power control system of the PC monitors activity of I/O devices and if upon the elapse of a first time interval a particular I/O device or combination of devices has not been accessed, one or more I/O devices are powered-down. Following power-down, the first time interval is incrementally increased if I/O activity immediately occurs thereafter, prior to elapse of a second time interval. This process may repeat itself several times until the first time interval reaches a maximum value. Alternatively, if, following power-down, I/O activity does not occur until after elapse of a third time interval, the first time interval is incrementally decreased until the first time interval reaches a minimum value. The system thereby automatically adapts to maximize power conservation during periods of low activity while preventing user disruption during periods of increased activity.

Power management system with adaptive control parameters for portable

A small computer having a card interface slot in a side of the computer. An inserted electronic card, the connector on its inserted end mates firmly with a connector at the inner end of the recess behind the slot. The user ejects an inserted card by sliding a slider which is positioned in a shallow recess on the bottom of the computer, near the slot. The slider is connected to an ejector which actually presses against the inner end of the card. By moving the slider with his thumb, the user can push the card out far enough to disengage the contacts of the card, and then can readily remove the card by hand or allow it to drop out.

Electronic system with compact card ejector

A personal computer which a microcontroller, separate from the main processor, is used for power-management functions. Under certain conditions, this power-management microcontroller can take control of the system bus. This provide BIOS-independent power management, and permits sophisticated power management to be performed without placing any burden or constraints on the user's choice of operating system or application software.

Portable computer with BIOS-independent power management

A computer system including an input/output (I/O) connector for connecting to an external data peripheral, where the computer includes circuitry for detecting the presence or absence of a load on a first pin and for providing power to the external data peripheral through a second pin of the I/O connector. In this manner, the external data peripheral need not include a separate power supply, but instead is sensed and powered by the computer itself through the I/O connector. In the preferred embodiment, the I/O connector is coupled to parallel port circuitry for interfacing to an external printer, and also to a floppy controller for interfacing with an external floppy drive, where the computer system further includes circuitry to switch from the printer controller to the floppy controller when an external floppy drive is connected to the I/O connector. In this manner, the same I/O port automatically serves either an external printer or an external floppy drive.

Computer system for sensing a cable-connected peripheral and for

Method and apparatus for effecting BIOS independent power management of a personal computer system having a processor complex connected via a system bus to at least one I/O device capable of operating in a reduced power consumption state. A power control system comprising a dedicated power management microcontroller monitors the activity of various I/O devices. When a particular device or combination of devices has remained inactive for the preselected time interval, the power control system issues a bus request to a processor complex. When the processor complex acknowledges the bus request, the power control system asserts control as master of the system bus and performs the operations necessary to cause at least one device to enter a reduced power consumption state. The power control system then surrenders control of the bus to the processor complex. In one aspect, a CPU clock controller is utilized to reduce the processing speed of the processor complex CPU.

BIOS independent power management for portable computer

A system for accurately predicting impending battery failure in battery powered electronic and electrical devices. The system continually monitors changes in battery voltage responsive to load changes and calculates a ratio of the change in voltage to the change in load. When the ratio exceeds a certain threshold value, indicating that the impedance of the battery has risen to near its final value, a user warning indication is generated.

System for indicating a low battery condition

A battery-powered lap-top computer has a main battery for ordinarily supplying power to the computer circuitry. A reserve battery is connected through a manual switch to the circuitry. When the main battery starts to lose its charge, the manual switch is operated to connect the reserve battery to the circuitry prior to removal of the main battery. A new main battery is installed and the switch is operated to disconnect the reserve battery from the circuitry. Provision is made for the main battery to slowly charge the reserve battery.

Growing community of inventors

Austin, TX, United States of America

Gregory N Stewart