Huntleigh Technology Limited

Greg Baily

Alan Beale

John Albert David Iles

Christopher Thomas Leyson

John Albert Davis Iles

A fluid level sensor to determine the level of fluid into a container used in negative pressure wound therapy. The sensor includes an array of conductive plates to produce electric field lines through the container and fluid within, the plates serving as the plates of a capacitor. The plates (-), are located close to the wall of the container, and are connected to a circuit board, electronics and software to determine the fluid level in the container based on the relative changes of capacitance between the plates. The capacitance is converted into a voltage signal representative of the change. The algorithms are designed to check the fluid level over predefined time periods to indicate the fluid level at more than one point and also track the fluid level. The fluid sensor can be used in the vertical, horizontal or other position of the container as desired.

Fluid level sensor

The inductive coupling for transferring electrical energy to or from a transducer and measuring circuit, consists of a male connector part () and a female connector part (). The male part (), includes a single layer solenoid () wound on a ferromagnetic rod (), the ends of the solenoid (and) connected to conductors (and) connected to an ultrasound probe (not shown) via cable (). The female part () includes a single layer solenoid (). The ends of solenoid () are brought out to terminals (and) to facilitate electrical connection to the ultrasound drive electronics (not shown). The coupling provides a simple sealed signal connection between the cable connected with the transducer and the measuring circuit electronics without the disadvantages of having exposed contact surfaces. The cable connector can be replaced if desired.

Growing community of inventors

Roath, United Kingdom

Greg Baily