Gm Global Technolgoy Operations, Inc.

Other

Glenn W Hoefflin

Christopher Jay Weingartz

David J Howe

William L Cousins

Colin Hultengren

Jayson S Schwalm

John William Boughner

Daniel J Wickman

Michael Partridge

Minh Q Truong

Binu Jose Kochucheruvil

A method for detecting and mitigating excessive clutch disc wear for a manual transmission includes determining if a clutch pedal position is depressed greater than or equal to a first predetermined pedal position threshold and if the vehicle speed is less than or equal to a predetermined vehicle speed threshold. The method further includes determining if the clutch pedal position is depressed greater than or equal to a second predetermined pedal position threshold when the clutch pedal position is depressed less than the first predetermined pedal position threshold. The method still further includes calculating a clutch disc heat flux value and a clutch disc surface temperature. The method further includes displaying an alert/warning and a remedial action message to a vehicle operator when the clutch disc surface temperature is greater than or equal to a predetermined surface temperature threshold.

Method for detecting and mitigating excessive clutch disc wear in manual transmissions

A method of controlling a dual clutch transmission (DCT) for a vehicle includes steps to reduce objectionable noise present during particular driving conditions and when the vehicle is operated using certain driving habits. A DCT engages at least two gear ratios at a time; one gear ratio for the current desired gear and a second gear ratio for the next likely gear. The method detects when conditions are favorable for the objectionable noise and takes action to remove the cause of the objectionable noise.

Method of controlling a dual clutch transmission

A method and system for controlling movement of an actuator fork of a transmission through a pre-synchronization phase of a synchronization event at a pre-synchronization fork velocity includes adjusting the level of fluid pressure applied to an actuator operatively attached to the actuator fork to control the pre-synchronization fork velocity within a predetermined range of a velocity target. The method determines, via a controller, the fork velocity during the pre-synchronization phase of a current synchronization event, compares the determined fork velocity to a velocity target, and adjusts the pressure level of fluid applied to an actuator piston of the actuator to control the velocity of the actuator fork within a predetermined range defined by the velocity target during a subsequent pre-synchronization phase. The velocity target may be defined for a shift type, such as a fast or slow shift, where the shift type is determined by the controller.

Method of controlling a synchronizer actuator fork of a transmission

A vehicle includes an engine, a transmission having a position-controlled clutch with a synchronizer sleeve and a synchronizer fork, an input member with an input speed, and an output member with an output speed, and a controller. The controller is programmed to register a slip-away condition when the input speed falls within a calibrated speed band and the output speed remains below a calibrated threshold speed. In response to the registered slip-away condition, the controller records a diagnostic code indicative of the synchronizer sleeve being disengaged, changes an engaged position of the synchronizer sleeve by a calibrated amount to thereby adapt the engaged position, and commands the clutch to disengage and the fork to move to a neutral position after increasing the engaged position. The controller also moves the synchronizer sleeve toward the adapted engaged position and applies the clutch when the synchronizer sleeve attains the adapted engaged position.

Synchronizer fork position control

A method of controlling movement of an actuator fork and attached synchronizer sleeve of a transmission through a pre-synchronization phase of a synchronization event at a pre-synchronization fork velocity below a breakaway velocity such that a strut is retained to the sleeve by a ball plunger for the duration of the pre-synchronization phase. A method of adjusting one of a pressure signal and a flow signal to an actuator piston to control movement of the actuator fork includes moving the fork from an initial disengaged position through a pre-synchronization phase of a synchronization event by controlling one of a pre-synchronization fluid pressure value and flow value, where the controlled pre-synchronization fluid value is less than a threshold value corresponding to a breakaway force of a ball plunger configured to selectively retain a strut assembly to a synchronizer sleeve operatively attached to the actuator fork.

Growing community of inventors

Fenton, MI, United States of America

Glenn W Hoefflin