Omron Corporation

Gen Yoneda

Yoshihiro Nagami

Masahito Tanaka

Ikuo Nanno

Akira Takaishi

Atsushi Mukai

Naoki Motoyama

Hirofumi Hosokawa

Naotaka Uchiyama

Takafumi Kishi

Maakazu Kido

Toshimichi Surga

Shigeyuki Kato

Provided is a technique that facilitates control of a navigation light which uses light-emitting diodes for a light source. This navigation light control system is provided with: a navigation light that has a light source for which a light-emitting diode is used; a power supply unit that supplies power to the navigation light; and a control device that controls lighting of the navigation light, wherein the control device is provided with a light source circuit that supplies the power received from the power supply unit to the light source, and a determination unit that determines failure of the light source on the basis of the value of the current flowing through a resistor connected to the light source circuit.

Illumination light control system and switching unit

Solid state relay

Module substrates each having the functions of input, power supply, and output/communication corresponding to the required model are attached to a base substrate having shared bus wiring. Thus, a main CPU of an input module can discriminate the respective module substrates to perform the control operation corresponding to the model, thereby sharing the module substrates among different models.

Electronic component and the method of using it

A controller controls a physical variable such as temperature of a controlled system. A variable calculator calculates and output a manipulated variable on the controlled system based on of a target value such as a target temperature and a feedback value such as the measured temperature of the controlled system. A dead-time compensator provides a dead-time compensated output using a model simulating the controlled system having a dead time and an idealized model having no dead time, based on the manipulated variable outputted from the variable calculator to carry out an ordinary control and a dead-time compensated control. A switch functions to select the dead-time compensated control by providing a dead-time compensated output to the variable calculator or an ordinary control providing no dead-time compensated output to the variable calculator. The dead-time compensated control is carried out at least during set point response of the controller.

Controller, temperature controller and heat processor using same

Growing community of inventors

Okayama, Japan

Gen Yoneda