Shanghai Jiao Tong University

Gehao Sheng

Xiuchen Jiang

Yadong Liu

Yue Hu

Xiaolei Xie

Yong Qian

Jiamei Liu

Lingyu Cao

Yun Hu

Chenlin Hu

Jiejie Dai

A parallel connection method and a device for multi-channel partial discharge (PD) signals have input sources of pre-processed and amplified signals received by multiple PD sensors. Then isolation and processing are provided to the signals to ensure that each signal is able to be self-triggered and unidirectional transmitted. Finally, processed signals of each channel are outputted. For ultra-high frequency (UHF) PD signal, the delay transmission is realized by a surface acoustic wave (SAW) delay line method. The present invention makes the amplified multi-channel PD signals self-trigger and unidirectional transmit though isolation processing and then realizes parallel connection without interference. The method also decreases signal transmission loss. Meanwhile, all the detected PD signals transmit on one signal bus through parallel connection method, so as to use only one set of acquisition unit to monitor and acquire the signals received by multiple sensors, which obviously lowers the system cost.

Parallel connection method and device for multi-channel PD signals

A maximum power output circuit for EHC and its design method are presented. The circuit is comprised of a magnetic core, that is, a primary coil and a secondary coil, with a load resistor and a capacitor parallel connected at the two ends of the secondary coil. The circuit enables the EHC to be always working at the maximum power output, thus realizing maximum power output of the energy harvesting power source.

Maximum power output circuit for an EHC and design method thereof

A method for detecting and locating faulty line on the distribution network circuit based on full waveform information, which uses the current data on the fault occurrence and whole-process operation of the compensation device to effectively solve such common problems as low fault current, poor reliability and low sensitivity in case of single-phase grounding fault to the low-current system through precise GPS synchronization. It improves the sensitivity and reliability of the grounding fault detection, which does not interfere with the system and is applicable to high-resistance grounding.

Method for locating distribution network circuit fault based on full waveform information

Growing community of inventors

Shanghai, China

Gehao Sheng