University of California

Gabriel S Phun

Shane Ardo

William White

Leanna Schulte

Rohit Bhide

Lawrence A Renna

Samuel Thomas Keene

Membranes for electrochemical technologies that operate at non-extreme acidic or basic conditions are described herein. The membrane can be a bipolar membrane having an anion-exchange layer, a cation-exchange layer, and a polymer layer containing a catalyst juxtaposed between the two layers. The catalyst can improve the rate for water dissociation and water formation at low applied bias thereby decreasing the overpotential and resistance for overall ion transport, especially when unequal pH values are used between the catholyte and anolyte.

Membranes for enhancing rates of water dissociation and water formation

Photochemical energy conversion is more efficient when a single light-absorbing unit is split into multiple light-absorbing units (N) that are each 1/N as thick as the single light-absorbing unit and thus use the same amount of material as the single light-absorbing unit. For electrocatalytic parameters relevant to water electrolysis, the maximum efficiency for solar-to-fuel conversion from a 1.75 eV bandgap material increases from approximately 1% for a single light-absorbing unit to greater than 20% for 128 identical stacked light-absorbing units. Alterations in utilization of photons results in a better match of the light-absorber power output to the load of the chemical transformation and in the case of high-quality light-absorbers there is an added benefit from radiative coupling between the light-absorbing units via photon recycling.

Optically thin light-absorbers for increasing photochemical energy-conversion efficiencies

Growing community of inventors

Irvine, CA, United States of America

Gabriel S Phun