United Technologies Corporation

Membrane Technology and Research, Inc

Foster Phillip Lamm

Louis J Spadaccini

He Huang

Harry Cordatos

Ingo Pinnau

Zidu Ma

Thomas Gregory Tillman

Alexander Chen

Louis Chiappetta, Jr

James R Irish

Stephen R Jones

Alexander G Chen

A non-porous membrane suitable for use in removing dissolved oxygen in a fuel deoxygenator device in an aircraft is produced by solvent casting. A first membrane layer is deposited on a substrate. A second membrane layer is deposited on top of the first membrane layer. Subsequent membrane layers may be deposited on top of the second membrane layer as desired. The resulting non-porous membrane allows little or no leaking of fuel across the membrane.

Method for producing a non-porous membrane

A deoxygenator includes a plurality of permeable membranes spirally wound about an exhaust tube for removing dissolved oxygen from a hydrocarbon fuel. The permeable membrane is spirally wrapped about the exhaust tube and defines fuel passages and exhaust passages. The fuel passages and exhaust passages alternate such that each fuel passage is bounded on each adjacent side by an exhaust passage. An oxygen partial pressure differential is generated across the permeable membrane to draw dissolved oxygen from fuel in the fuel passage. The dissolved oxygen is then communicated through openings about the circumference of the exhaust tube and out the deoxygenator.

Spiral wound fuel stabilization unit for fuel de-oxygenation

A method for preventing fuel from migrating, i.e., infiltrating, into a mircoporous polymer membrane, such as that used in a fuel deoxygenator device of an aircraft to remove dissolved oxygen from the fuel, includes heating the membrane to reduce the size of micropores in the membrane from a first size to a second size that is large enough to allow migration of oxygen through the membrane and small enough to prevent migration of fuel into the membrane. The membrane is an amorphous fluoropolymer on a PVDF substrate and the micropores are reduced in size by heating the membrane at a temperature between 130&#xb0; C. and 150&#xb0; C. for 2 hours.

Method for preventing fuel infiltration into microporous polymer membranes

Growing community of inventors

South Windsor, CT, United States of America

Foster Phillip Lamm