Integrated Device Technology, Inc.

Feng-Jung Huang

Jean-Marc Roger Mourant

Shawn Bawell

Chuying Mao

Ran Li

Hybrid-coding, multi-cell architecture and operating techniques for step devices provide advantages over binary-coded and thermometer-coded step devices by minimizing or avoiding glitches common in the transient response of binary-coded step devices and by minimizing or avoiding significant increases or degradation in one or more of area, package dimensions, pin counts, power consumption, insertion loss and parasitic capacitance common to thermometer-coded step devices having equivalent range and resolution.

Multi-bit cell attenuator

Variable feedback architecture and control techniques for variable gain amplifiers (VGAs) concurrently maintain, across a wide range of VGA gain settings, minimal input and output impedance variations, a low noise figure, low rates of change in noise figure, high signal-to-noise ratio (SNR), high quality of service (QoS), low distortion, high and relatively constant output third order intercept point (i.e., IP3 or TOI). Variable feedback counteracts impedance variations caused by gain variations. Compared to conventional high performance VGAs, noise figure is lower (e.g. 3 dB lower at maximum gain and 12 dB lower at minimum gain) and relatively constant, IP3 is higher and relatively constant, small signal third order intermodulation signal (IM3) tone slope is relatively constant and input and output impedances are relatively constant. As gain decreases, the noise figure advantage is nearly dB per dB compared to conventional high performance VGAs.

Low noise variable gain amplifier utilizing variable feedback techniques with constant input/output impedance

Hybrid-coding for improving transient switch response in a multi-cell programmable apparatus

An impedance-matched amplifier utilizing a feed-forward linearization technique involving multiple negative feedbacks and distortion compensation without active tail current sources reduces noise, distortion, power consumption and heat dissipation requirements and increases linearity, dynamic range, signal-to-noise-ratio, sensitivity and quality of service. Some differential amplifier embodiments of the invention consume less than 2 mA at 5 Volts or 10 mW power consumption per 1 mW in peak and sustained output IPperformance above 40 dBm. In contrast, for an input signal frequency of 200 MHz, a 16 dB gain state-of-the-art differential amplifier consumes 100 mA at 5 Volts with a peak output IPof 36 dBm while an implementation of a 16 dB gain differential amplifier embodying the invention consumes 77.7 mA at 5 Volts with a peak output IPof 46 dBm and sustained at or above 40 dBm over a wide frequency range.

Growing community of inventors

San Antonio, TX, United States of America

Feng-Jung Huang