The Singer Company

Erich Kothe

George Obermann

William H Redfield

The electric motor drives high and low speed drive pinions through reduction gearing. A low torque capacity clutch is located in the reduction gear train to the low speed pinion to permit the user to turn the manual shift to position the timer. The various program cams are driven by a drive member carried by an arbor on which the cams are mounted. The cams are independently spaced relative to the arbor and housing so any may be omitted as desired. The pulsing cam is mounted on the arbor and driven by the high speed pinion. The switch blades are essentially straight, the only forming being at the contact end where contact position or pressure will not be affected.

Dryer timer

If the pressure switch pre-loading cam has been set for a level above medium the pressure switch is returned to medium after completion of the wash cycle by momentary energization of the solenoid to unlatch the slider from the lobed cam. The slider carries the high and extra high settings and when it is disconnected from the cam the torsion spring on the cam shaft can drive the cam back to medium by pushing the slider out of the way. This arrangement prevents inadvertent repeated use of the higher water level settings, thus preventing inadvertent use of hot water.

Growing community of inventors

Schaumburg, IL, United States of America

Erich Kothe