Hitachi Koki Co., Ltd.

Eppendorf Himac Technologies Co., Ltd.

Eiichi Fukuhara

Hiroatsu Toi

A valve bridge portion, in which four valves A to D are connected in a bridge shape, is interposed between sample lines to a rotor of a continuous centrifuge. A microcomputer is able to open and close the valves A to D independently and is capable of switching between top feed and bottom feed to the sample line. When sample supply is started, switching between the top feed and the bottom feed is performed multiple times, and in the middle of switching and sending a sample liquid, the microcomputer executes an operation of temporarily increasing a liquid pressure multiple times by temporarily closing an outlet valve (C or D) and then immediately opening the valve. As a result of repeating the operation of switching between the said sample feed directions and temporarily increasing the liquid pressure, air that accumulates inside the rotor can be effectively discharged.

Continuous centrifuge and air discharge method for continuous centrifuge

A continuous centrifuge includes: a cylindrical rotor configured to separate a specimen; a centrifuging chamber accommodating the rotor; a driving unit configured to rotate the rotor; a specimen line configured to continuously supply and discharge the specimen to and from the rotor during rotation of the rotor; and a controller configured to control the driving unit. The control unit has a cleansing mode which flows a liquid chemical through the specimen line so as to conduct sterilization and/or cleansing while rotating the rotor.

Continuous centrifuge

A centrifuge includes a rotor, a rotation shaft which has a through-hole communicated with an interior of the rotor, a face seal which slidingly contacts an end of the rotation shaft and has a path communicated with the through-hole of the rotation shaft, a wall member which accommodates the face seal, a sample transfer unit which transfers a sample through the rotor, and a coolant circulation unit which circulates a coolant to the wall member. The sample transfer unit transfers the sample by pressure so that a pressure of the sample flowing through a portion where the rotation shaft and the face seal slidingly contact with each other is higher than a pressure of the coolant flowing through the wall member.

Growing community of inventors

Ibaraki, Japan

Eiichi Fukuhara