Molex Corporation

Edward Seamands

Jay H Neer

Brian Keith Lloyd

Michael F Magajne

Christopher P Dirkers

Michael J Miskin

Kenneth F Janota

Richard A Hays

Munewar Ahmad

An adapter module is provided with a bail latch mechanism that serves to engage and disengage the frame into which the adapter module fits. The bail latch is movable between two positions and it engages a cam member formed as part of the module that cams two opposing free ends of the bail latch inwardly into the module to thereby release it from the adapter frame. The adapter frame includes a wear sleeve that cams the bail latch free ends inwardly during some insertions of the module. C-shaped press fit pins are made with the adapter frame for better engagement with the circuit board.

Adapter module with a compliant press-fit mounting pins

Adapter module retention latches

A cable connector is provided that has a connector housing that is thin and takes the form of a wafer. Terminals are held within the housing and termination portions extend lengthwise from the terminals. The termination portions extend out from the housing for terminating bare conductors of signal wires to them. A grounding shield is provided that extends over the signal terminals from their contact portions at the front end of the connector to their rear termination portions. The grounding shield thereby provided a ground extent over the termination area that increases the electrical affinity of the signal wires to the grounding shield so as to reduce crosstalk and noise during operation at high frequencies. In one embodiment, the grounding shield includes a separate extension that is connected to the base grounding shield. In another embodiment, the grounding shield has a length sufficient to extend over the termination area.

Cable connector with shielded termination area

A connector for connecting cables to a pin header has a connector body portion that incorporates a strain relief member applied to the cables as part of the connector body portion. The strain relief member includes a cable clamp having a series of grooves that are separated by intervening land portions. The grooves receive the cables and particularly space them. A stop is formed in the clamp to isolate the cable end. The leads of the cable are terminated to corresponding tail portions of contacts of the connector. These tail portions are maintained in the same plane to enhance the electrical performance of the connector. An insulative material is molded over the tail portions and the cable clamp to form a connector with a cable clamp formed integrally with the body of the connector.

Connector with integrated strain relief

Growing community of inventors

Little Rock, AR, United States of America

Edward Seamands