Massachusetts Institute of Technology

Dodd Joseph Gray

Rajeev J Ram

Parthiban Santhanam

Amir Hossein Atabaki

Marc De Cea Falco

Optical read-out of a cryogenic device (such as a superconducting logic or detector element) can be performed with a forward-biased optical modulator that is directly coupled to the cryogenic device without any intervening electrical amplifier. Forward-biasing at cryogenic temperatures enables very high modulation efficiency (1,000-10,000 pm/V) of the optical modulator, and allows for optical modulation with millivolt driving signals and microwatt power dissipation in the cryogenic environment. Modulated optical signals can be coupled out of the cryostat via an optical fiber, reducing the thermal load on the cryostat. Using optical fiber instead of electrical wires can increase the communication bandwidth between the cryogenic environment and room-temperature environment to bandwidth densities as high as Tbps/mmusing wavelength division multiplexing. Sensitive optical signals having higher robustness to noise and crosstalk, because of their immunity to electromagnetic interference, can be carried by the optical fiber.

Forward-biased modulator for cryogenic optical readout

Contrary to conventional wisdom, which holds that light-emitting diodes (LEDs) should be cooled to increase efficiency, the LEDs disclosed herein are heated to increase efficiency. Heating an LED operating at low forward bias voltage (e.g., V&#x3c;kT/q) can be accomplished by injecting phonons generated by non-radiative recombination back into the LED's semiconductor lattice. This raises the temperature of the LED's active rejection, resulting in thermally assisted injection of holes and carriers into the LED's active region. This phonon recycling or thermo-electric pumping process can be promoted by heating the LED with an external source (e.g., exhaust gases or waste heat from other electrical components). It can also be achieved via internal heat generation, e.g., by thermally insulating the LED's diode structure to prevent (rather than promote) heat dissipation. In other words, trapping heat generated by the LED within the LED increases LED efficiency under certain bias conditions.

Thermo-electrically pumped light-emitting diodes

Phonon-recycling light-emitting diodes

Contrary to conventional wisdom, which holds that light-emitting diodes (LEDs) should be cooled to increase efficiency, the LEDs disclosed herein are heated to increase efficiency. Heating an LED operating at low forward bias voltage can be accomplished by injecting phonons generated by non-radiative recombination back into the LED's semiconductor lattice. This raises the temperature of the LED's active rejection, resulting in thermally assisted injection of holes and carriers into the LED's active region. This phonon recycling or thermo-electric pumping process can be promoted by heating the LED with an external source (e.g., exhaust gases or waste heat from other electrical components). It can also be achieved via internal heat generation, e.g., by thermally insulating the LED's diode structure to prevent (rather than promote) heat dissipation. In other words, trapping heat generated by the LED within the LED increases LED efficiency under certain bias conditions.

Growing community of inventors

San Francisco, CA, United States of America

Dodd Joseph Gray