Nuscale Power, LLC

Derek Noel

Christian Lobscheid

Steven W Shaw

A representative cooling system for a nuclear reactor control rod drive mechanism (CRDM) includes an evaporation section located within or next to the CRDM and a condensation section fluidly coupled to the evaporation section. The cooling system includes a set of heat fins coupled to drive coils in the CRDM and heat pipes that extend through the drive coils and heat fins. A fluid evaporates while in the evaporation section of the heat pipes from heat generated by the CRDM and moves out of the evaporation section into the condensation section in the heat fins. The fluid cools and condensates while in the condensation section, recirculating back into the evaporation section. This passive natural circulation cooling system reduces or eliminates the number of water hoses, piping, and other water pumping equipment typically used for cooling a CRDM thereby increasing nuclear reactor reliability and simplifying nuclear reactor operation and maintenance.

Control rod drive mechanism with heat pipe cooling

A bolt installation and removal (BIR) system is used for assembling and disassembling a nuclear vessel. The BIR system includes a platform with a stand for supporting the nuclear vessel. A track extends around an outside perimeter of the platform and multiple tool carts include wheels that roll on the track. Tool towers are located on the carts and include tool assemblies configured to install and remove bolts on the nuclear reactor vessel. Magazine towers also extend up from the tool carts next to the tool towers and include magazines that hold bolts for exchanging with the tool assemblies. Drive mechanisms move tool heads in the tool assemblies around a first vertical axis, vertically up and down, and laterally to more simply and reliably install and remove the bolts in a radioactive underwater environment.

Bolt installation and tensioning system

A containment seal seals a cable or tube to an opening accessing a containment vessel. The containment seal includes a lower body that attaches over the opening into the containment vessel. The cable or tube is inserted through a hole that extends axially through an upper body of the containment seal. Compression fittings are attached to the top and bottom ends of the upper body sealing the cable inside of the upper body. The cable sealed inside of the upper body in inserted through the lower body and into the opening accessing the containment vessel and a lower portion of the upper body is seated into the opening formed in the lower body. A retaining device compresses the upper body down against the lower body forming a seal between the upper body and lower body.

Growing community of inventors

Albany, OR, United States of America

Derek Noel