Broadcom Corporation

Avago Technologies International Sales Pte. Limited

Dengwei Fu

Colin Fraser

Arya Behzad

Amir Dov Eliaz

Ali Afsahi

Daniel Stopler

Konrad W Kratochwil

Navid Lashkarian

Utku Seckin

Sandeep Shenoy

High peak-to-average ratio of OFDM signals requires large back-off from an RF power amplifier's saturation power. A spectral shaper device therefore increases the output power and efficiency of the power amplifier. The shaper device performs linearization through digital predistortion, based on an out-of-band regrowth limit, as well as the EVM requirement for a particular data rate. The shaper can distribute the error energy, precisely, over frequencies such that each of the inband and out-of-band requirements is independently and individually met. The shaper distributes error energy to frequency regions in the spectrum to the maximally allowed by the standards and regulations, while not increasing the total error. The error energy is kept to the minimum where it is crucial in meeting EVM requirements. In this way, the shaper maximizes the allowable output power of the nonlinear power amplifier.

Time domain transmitter signal shaping

Communication processing paths include distortions, such as DC offset in the baseband analog path, local oscillator feed-through distortion, and nonlinearity of gm's and power amplifiers which are calibrated for, separately or in combination. The cascaded DC offset and nonlinear distortions are modeled separately or in combination using even-and-odd order polynomials. A loopback path from the output of one or more distortion causing devices passes through a measurement and calculation module. The calculation module calculates predistortion polynomial's coefficients which will be stored in a look-up table to be used by a baseband predistorter to calibrate the path. The look-up table is stored locally or remotely.

Calibration of communication processing path

Growing community of inventors

Sunnyvale, CA, United States of America

Dengwei Fu