Other

University of Florida Research Foundation Inc

Dawei Zhou

Michael J Burns

Ward Ruby

Thomas Mareci

High-Tc superconducting ceramic oxide products and macroscopic and microscopic methods for making such high-Tc superconducting products. Completely sealed high-Tc superconducting ceramic oxide provides are made by a macroscopic process including the steps of pressing a superconducting ceramic oxide powder into a hollow body of a material inert to oxygen; heat treating the superconducting ceramic oxide powder packed body under conditions sufficient to sinter the ceramic oxide powder; and then sealing any openings of the body. Optionally, a waveform or multiple pulses of alternate magnetic filed can be applied during the heat treatment. The microscopic method of producing a high-Tc superconducting ceramic oxide product includes the steps of making a high-Tc superconducting ceramic oxide thin film; optionally sintering the deposited thin film in a magnetic filed; and removing partial oxygen content of the thin film by a scanning tunneling electron treatment machine to form a microscopic insulation layer between two high-Tc superconducting domains of the thin film.

High-TC superconducting ceramic oxide products and macroscopic and microscopic methods of making the same

Method of making high-Tc superconducting ceramic oxide tape

High-Tc superconducting ceramic oxide products and macroscopic and

Three-dimensional RF coils suitable for use in NMR spectroscopy or imaging are described, as well as methods for making such coils. The coil is made from a thin-walled, non-magnetic, electrically insulating tube. The tube is then masked and a first conducting layer is applied, e.g., by evaporation. An additional insulating layer is provided on top of the first conducting layer, and then a second conducting layer is applied. An optional additional insulating layer may then be applied over the second conducting layer. The first and second conducting layer, in combination, are electrically connected to form a self-resonant structure at the selected frequency of the NMR apparatus. The coil may be fine-tuned conventionally by means of a series or parallel capacitor, or by changing the position of a conductive ring around the outside of the coil. Alternately, two tubes may be used, with only one conducting layer deposited on each. If two tubes are used, they are dimensioned to allow one tube to fit within the other. The two tubes may be twisted or telescoped to permit varying degrees of alignment of the conductive patterns deposited on the two tubes, which will serve to fine-tune the NMR tube's resonant frequency.

Method for making an NMR coil

High-Tc superconducting ceramic oxide products and macroscopic and microscopic methods for making such high-Tc superconducting products. Completely sealed high-Tc superconducting ceramic oxide products are made by a macroscopic process including the steps of pressing a superconducting ceramic oxide powder into a hollow body of a material inert to oxygen; heat treating the superconducting ceramic oxide powder packed body under conditions sufficient to sinter the ceramic oxide powder; and then sealing any openings of the body. Optionally, a waveform or multiple pulses of alternate magnetic field can be applied during the heat treatment. The microscopic method of producing a high-Tc superconducting ceramic oxide product includes the steps of making a high-Tc superconducting ceramic oxide thin film; optionally sintering the deposited thin film in a magnetic field; and removing partial oxygen content of the thin film by a scanning tunneling electron treatment machine to form a microscopic insulation layer between two high-Tc superconducting domains of the thin film.

Growing community of inventors

Gainesville, FL, United States of America

Dawei Zhou