Tesla Motors, Inc.

Tesla, Inc.

David Wheeler

Adam Scott Kilgore

Brenda Cucci

Austin Lawrence Newman

Daryl Zalan

Chris McCarthy

Jacob Warman

John Hughes

Peter Dore Rawlinson

Alan Paul Clarke

Ian Craven

Joris Aerts

Dan Adams

Scott P Cromwell

Robert E Mooney

Robert B Mooney

A system for a vehicle includes: a door; an electric actuating motor that opens and closes the door, the electric actuating motor configured for actuating at a hinge of the door; a push-open actuator mounted at a rear of the door, the push-open actuator configured for pushing against a body of the vehicle; and a wireless device configured for communications to the vehicle. A system for a vehicle includes: a front door; a rear door behind the front door, the rear door having a dual-hinge design that opens and closes in a substantially vertical direction; an electric actuating motor that opens and closes the front door, the electric actuating motor configured for actuating at a hinge of the front door; and a wireless device configured for communications to the vehicle.

Vehicle front door power opening system

A door handle assembly extends a door handle in parallel from an outer surface of a vehicle door and retracts the door handle until it is flush with the outer surface. The door handle assembly includes a door handle formed from a planar handle member and a handle base member. The planar handle member is coupled to the handle base member and a swing arm coupled to the backside of the handle base member extends and retracts the door handle. A first upper fork is rotably coupled to a backside of the handle base member near the distal portion of a first post portion and a second upper fork is rotably coupled to the backside of the handle base member near the distal portion of a second post portion. The lower dual fork portion of the swing arm pivots about a shaft mounted to an inner door surface.

Door handle apparatus for vehicles

A door handle assembly for a vehicle door includes a door handle operated using a controller and sensors. In the door interior, an upper portion of a swing arm connects to a first post and a second post portion of the door handle. The lower portion of the swing arm, rotably attached to a shaft on the inner door, pivots between an extended and retracted position. When an extension force sensor contacts the upper portion of the arm, the extension force sensor on the inner door surface generates an extension force response signal. A retraction force sensor on the lower portion of the arm generates a retraction force response signal when the retraction force sensor on the lower portion of the arm contacts a flush adjuster rod. Both extension and retraction force response signals are used by the controller to operate the door handle.

Controller apparatus and sensors for a vehicle door handle

Aspects of the disclosure provide for controlling a hood latch using an electrically actuated primary hood latch and an electrically actuated secondary hood latch. To open the hood of the vehicle, a person presses a hood release button. Before attempting to release either the primary hood latch or secondary hood latch, a determination is made whether a vehicle speed of the vehicle is below a minimum vehicle speed threshold. If the vehicle speed is below this threshold, both the primary electrical actuator for the primary hood latch and the secondary electrical actuator for the secondary hood latch are triggered, thereby releasing hood from a closed position into an open position. When the vehicle speed is above this vehicle speed threshold, only the primary electrical actuator for primary hood latch is triggered; leaving the hood in a partially open position held in place by the secondary hood latch.

Power release hood latch method and system

Aspects of the disclosure provide a door handle assembly used in a vehicle door having an illumination module and illumination source that directs light in a first direction and a second direction using a pair of light pipes. The door handle from the door handle assembly includes a first illumination aperture oriented in the first direction and a second illumination aperture oriented in the second direction. As the illumination source generates light, the first light pipe receives a first portion of light and directs it toward a first illumination surface and the first illumination aperture in the first direction. By molding the second light pipe around the first light pipe, remaining light is captured from the illumination source as a second portion of light. The second portion of light reflects along the interior surfaces of the second light pipe towards the second illumination surface oriented in the second direction.

Illumination apparatus for vehicles

Growing community of inventors

San Carlos, CA, United States of America

David Wheeler