Gm Global Technolgoy Operations, Inc.

The Raymond Corporation

David James Reed

Kenneth L Kaye

Derek R Lebzelter

Jeffrey Allan Rock

Richard P Corey

Thaddeus J Grey

David Rea

Matthew Howard Fronk

Angelo T Caruso

Kevin Sampson

A battery management system is provided. The battery management system includes a controller comprising at least one processor and at least one memory. The at least one memory comprising instructions executed by the at least one processor to receive load information about a load from a load sensor, receive battery operating information from a battery sensor, determine a number of battery modules needed to supply the load and operate each battery module at or below a preferred discharge rate based on the load information and the battery operating information, select a group of battery modules included in the battery based on the number of battery modules and the battery operating information, each battery module included in the group of batteries having a current depth of discharge within the preferred depth of discharge range, and instruct the battery to supply the load using the group of battery modules.

Battery management systems and methods

System and methods for measuring operating parameters of a fuel cell system are presented. In certain embodiments, the systems and methods may be configured to measure a high frequency resistance of a fuel cell system. A method for measuring a high frequency resistance of a fuel cell system may include inducing a current signal and a voltage signal through the FC system at a center frequency using a switched load. The current signal and the voltage signal may then be measured and filtered to isolate the current signal and the voltage signal from noise signals occurring in the FC system. A high frequency resistance of the FC may then be calculated based on the filtered current and voltage signals.

Systems and methods for measuring high frequency resistance in a fuel cell system

A method for providing calibration synchronization pulses in a pulse width modulation (PWM) signal including fuel cell voltage measurement pulses. The method includes providing a sequence of voltage signals representative of the voltage of the fuel cells in a fuel cell group, where the sequence of voltage signals are provided in the order of the position of the fuel cells in the group. The method also includes providing a sequence of calibration pulses and combining the sequence of voltage signals and the sequence of calibration pulses so that the calibration pulses are provided before a voltage signal of a first cell in the group. The method modulates the combined sequence of the voltage signals and the calibration pulses using an inverted saw tooth wave to provide the PWM signal, where a width of the pulses representing the voltage signals are proportional to a width of the pulses representing the calibration pulses.

Method of providing a calibrating reference voltage and index synchronization sequence for a cell voltage measurement system

A method for providing calibration and synchronization pulses in a pulse width modulation (PWM) signal including cell voltage measurement pulses, where the calibration pulses are four calibration pulses having a pattern of a narrow width high voltage pulse followed by a wide width low voltage pulse followed by a narrow width high voltage pulse followed by a wide width low voltage pulse that has a very low probability of occurring in a practical fuel cell system. The method modulates a combined sequence of the voltage measurement signals and the calibration pulses using an inverted saw tooth wave to provide the PWM signal, where a width of the pulses representing the voltage signals are proportional to a width of the pulses representing the calibration pulses.

Frame sequence for a cell voltage measurement system with a low probability of natural occurrence

A health monitoring system for a fuel cell stack using current fuel cell architecture to enable the electronic control unit (ECU) to continue to monitor the health of the fuel cell stack despite a component failure. The system uses an embedded measurement module (EMM) connected to a group of fuel cells in the fuel cell stack to monitor the health of that group of fuel cells. The EMM produces a pulse width modulation signal that is sent to the ECU. A total voltage value for the group of fuel cells is embedded into the calibration signal or end of frame sequence. The ECU uses an algorithm to determine a missing voltage of at least one fuel cell in the event of the component failure of that fuel cell by adding up the cumulative value for each fuel cell reporting their voltage and subtracting that value from the total voltage value found in the end of frame sequence.

Growing community of inventors

Fairport, NY, United States of America

David James Reed