Alcor, Inc.

Other

David J Margraf

Joe L Portman, Jr

Joseph L Portman, Jr

A piezoelectric device is used to determine the viscosity of a fluid. A piezoelectric driver is resiliently attached to a base that is isolated from vibrations. A piezoelectric receiver and a probe are resiliently attached to the piezoelectric driver so that the receiver and probe move in response to motion of the piezoelectric driver, and the piezoelectric receiver gives an electric signal out proportional to motion of the system. The entire system is set to operate near the resonant frequency for the receiver/probe. By applying an oscillating sine wave voltage such as 140 hertz, to the piezoelectric driver, and immersing the probe first in a fluid of known high viscosity, and then in a fluid of known low viscosity, calibrated outputs are obtained from the piezoelectric receiver. Next by exchanging a fluid of unknown viscosity for the known fluids, a third output is obtained that represents the unknown viscosity.

Piezoelectric viscometer

A piezoelectric device is used to determine the absolute weight of an unknown sample by comparison to a control sample whose weight is known. A piezoelectric driver is resiliently attached to a base that is isolated from vibrations. A piezoelectric receiver and a reed are resiliently attached to the piezoelectric driver so that (1) the reed is moved in response to motion of the piezoelectric driver, and (2) the piezoelectric receiver gives an electric signal out proportional to motion of the system. The entire system is set to operate on the leading edge of the resonant frequency for the system. By applying an oscillating sine wave voltage, such as 140 hertz, to the piezoelectric driver, and by applying a known mass to the tip of the reed, a first output is obtained from the piezoelectric receiver which represents the calibrated weight. Next by exchanging an unknown sample for the known mass, a second output is obtained that represents the second weight. By a ratio of the second output/first output (or a signal equivalent to the weights being measured), the absolute weight of the unknown sample is determined.

Piezoelectric weighing device

A piezoelectric device is used to determine a ratio of a second weight with an original weight where the second weight is less than the original weight. A piezoelectric driver is resiliently attached to a base that is isolated from vibrations. A piezoelectric receiver and a reed are resiliently attached to the piezoelectric driver so that (1) the read is moved in response to motion of the piezoelectric driver, and (2) the piezoelectric receiver gives an electric signal out proportional to motion of the system. The entire system is set to operate on the leading edge of the resonant frequency for the system. By applying an oscillating sine wave voltage, such as 140 hertz, to the piezoelectric driver, and by applying an unknown mass to the tip of the reed, a first output is obtained from the piezoelectric receiver which represents the original weight. Next by removing part of the mass by any convenient means, such as heat, a second output is obtained that represents the second weight. By a ratio of the second output/first output (or a signal equivalent to the weights being measured), the percent of the mass remaining is determined.

Growing community of inventors

New Braunfels, TX, United States of America

David J Margraf