Teradyne, Inc.

Other

David J Groessl

Kurt E Schmidt

Frank R Bauer

Yun Zhang

Joseph S Rosen

Richard G Winkler

A method characterizes a customer line for data transmission. The method includes measuring electrical properties of the customer line from a central location, identifying a line model from the measurements, and identifying a modem model for a modem selected for use with the customer line. The modem model gives performance data for the selected modem. The method also predicts performance data for the customer line when operated with the selected modem by combining the line and modem models.

Predicting performance of telephone lines for data services

A method and system for qualifying telephone lines for high speed data services. The system takes measurements on a line under test and matches those measurements to a model of a line. The model of the line is used to predict whether the line will support data services at a particular level. If the model of the line includes a service affecting condition that is removable from the line, a new model is created reflecting the line as it would appear with the service affecting condition removed. The new model is then used to predict performance. If the required performance level is predicted based on the new model, the line is categorized as a line that can not support the required level of data services, but could if repaired. In this way, an accurate and useful prediction of line performance is provided.

Method and apparatus for bridged tap impact analysis

A method and apparatus to non-interactively test telephone networks and more specifically to localize faults such as resistive faults in the subscriber loop of the telephone network is presented. The method and apparatus determine whether the fault is in the tip line or ring line of a phone line. The existence of a fault voltage, if any, is also determined. The resistance of the tip line to ground and the resistance of the ring line to ground is measured. A fault resistance is calculated from this information, from which the location of the fault is determined.

Method of performing non-interactive resistive fault location

An automated telephone line test system that is well suited for determining the location of faults within a telephone network. The telephone line test system uses time domain reflectometry to aid in locating the faults. The time domain reflectometry unit is connected through a switch in the network so that the time domain reflectometry unit can be connected to multiple lines without human intervention. Parameters of the time domain reflectometry signals are controlled so that reflections from the switch do not interfere with measurement of parameters on the faulty line.

Method and apparatus for fault segmentation in a telephone network

A line test system for diagnosing and segmenting faults in a switched telephone network. The system includes a remote measurement unit installed at a switch and a test system controller. The test system controller stores data about operating parameters of each of the subscriber lines when they are believed to be free of faults. When a fault is reported, the parameters are measured again. By comparison of the measured parameters with the stored parameters, the fault can be segmented between the premise and the network. Segmentation is performed using knowledge based analysis techniques. The actual source of the fault once it is repaired is also stored by the test system controller. This historical information is used to improve the accuracy of the knowledge based analysis techniques used for segmentation. The line test system is capable of detecting the presence of high impedance ringers. Information on high impedance ringers is used to distinguish between lines that contain open circuit faults and lines that are terminated with high impedance ringers.

Method and apparatus for high impedance ringer detection

A line test system for diagnosing and segmenting faults in a switched telephone network. The system includes a remote measurement unit installed at a switch and a test system controller. The test system controller stores data about operating parameters of each of the subscriber lines when they are believed to be free of faults. When a fault is reported, the parameters are measured again. By comparison of the measured parameters with the stored parameters, the fault can be segmented between the premise and the network. Segmentation is performed using knowledge based analysis techniques. The actual source of the fault once it is repaired is also stored by the test system controller. This historical information is used to improve the accuracy of the knowledge based analysis techniques used for segmentation.

Growing community of inventors

Vernon Hills, IL, United States of America

David J Groessl