Sargent Manufacturing Company

Sargent Manufacturing

David A Sorensen

Darren C Eller

Todd C Zimmer

Ronald S Slusarski

Thomas A Pelletier

Paul Nunez

Robert Glenn

Paul H DeMarseilles

Mohammed A Haq

Arnon Alexander

A lock mechanism for use with lever handles includes a lock core and a latch mechanism that is rigidly connected to the lock core to prevent the lock core from rotating in the door. Through-bolts are not needed, allowing a small diameter rose to be used. Stops and a spring return mechanism are entirely located within the lock core, allowing the rose to be thin. The lock core defines the rest position for the lever handles at an angle slightly above horizontal. To avoid the necessity for producing different locks in left and right-hand configurations, the lock core is made substantially symmetrical about a vertical plane, instead of a horizontal plane, and the inner and outer sides of the lock mechanism can be interchanged. A heavy-duty locking piece, including a pair of locking lugs that directly engage the lock core near its inner perimeter, allow the lock to withstand abusive forces applied through the lever handle. Endplay is nearly completely eliminated to provide a quality feel through the use of collars that connect the interchangeable inner and outer sides of the lock to the lock core.

High strength lever handle lock mechanism

A free-wheeling lock mechanism for a cylindrical door lock includes inner and outer spindles directly connected to corresponding inner and outer lever handles, a latch retractor located between the spindles and a cylindrical outer cam located within the outer spindle. The outer cam has an ear on its perimeter that moves from a forward to a rearward position as the outer cam is rotated to operate the latch retractor. A cylindrical locking plug is located within the outer cam and has an outwardly projecting finger that connects and disconnects the outer cam from the outer spindle to lock and unlock the mechanism as the locking plug slides axially relative to the outer cam. In the unlocked position the finger projects outwardly through a slot in the outer cam into a longitudinally oriented portion of a T-shaped slot in the spindle. In the locked position the finger projects outwardly through the outer cam slot into a circumferential portion of the spindle slot.

Free-wheeling lever handle lock mechanism

A motorized lock actuator adapted to replace a mechanical lock actuator in preexisting and installed lock assemblies to convert them to electronic operation includes an electrically insulated motor housing and at least one electrically insulated bushing on the motor shaft to prevent electrostatic discharge and EMI/RFI interference from damaging the electronic lock controller. An alignment spring is used to improve operation in misaligned lock assemblies, and a key cam of self lubricating and electrically insulating plastic provides reliable low friction operation for a sliding locking slide assembly.

Motorized lock actuators

A cylindrical lever handle lock mounted in a door panel having a transverse bore therethrough is secured against rotation due to torque applied to the lever handles. The lock mechanism includes a lock chassis having a pair of chassis support members each having a pair of slots on their peripheries. A pair of support plates having inwardly extending tongue members slide into the support plate openings. The support plates are of a diameter greater than the bore and have openings in the periphery of each which corresponds with a hole drilled in the door panel outside of the bore. Door handle roses are secured over the support plates by through-bolts which pass through the support plate peripheral openings and the drilled door holes. Threaded bushings are also utilized to tighten the support plates on either side of the bore. Additional tabs and screws may be used to non-rotatably secure the support plates to the door panel. Separate coil spring assemblies mounted in the rose plates ensure return of the lever handles to their original position despite wear and abuse.

Cylindrical lever handle lock

Growing community of inventors

Hamden, CT, United States of America

David A Sorensen