Western Digital (fremont), Inc.

Read Rite Corporation

Curtis V Macchioni

Matthew R Gibbons

Steven C Rudy

Yun-Fei Li

Carlos Corona

Changhe Shang

Zhigang Bai

Ut Tran

Tao Pan

Yong Shen

Jonas Andrew Goode

Billy W Crue, Jr

Yunhe Huang

Keith Y Sasaki

Steven J Plewes

Michael T Harnischfeger

Andrei F Khapikov

A method of forming a single layer inductive coil structure includes forming a first conductive coil on a substrate, forming an insulating layer by atomic layer deposition (ALD) over the first coil and the substrate, and forming one or more additional conductive coils on each of adjacent sides of the first coil insulated from the first coil and the substrate by the insulating layer. A method of forming a stacked layer inductive coil includes forming a cavity in a substrate, forming a first coil in the cavity wherein the cavity has an atomic layer deposition (ALD) layer, forming a second coil in the cavity adjacent to the first coil and separated by the ALD layer from the first coil, forming an insulating layer over the first and second coil, and forming a third coil on the insulating layer.

Short yoke length coils for magnetic heads in disk drives

A slider includes a transducer including a magnetic structure having a front edge and a back edge. The slider further includes an electronic lapping guide (ELG) substantially coplanar with the magnetic structure and having a top edge and a bottom edge. The slider further includes a plurality of pads configured to calibrate a sheet resistance of the ELG and an offset of the ELG.

Electronic lapping guide in a magnetic recording transducer

A method for providing an electronic lapping guide (ELG) for a structure in a magnetic transducer are described. The structure has a front edge and a back edge. The ELG includes a stripe having a top edge and a bottom edge. The method includes calibrating a sheet resistance of the stripe and calibrating an offset of the top edge of the stripe from the back edge of the structure. The method further includes terminating the lapping based at least on the sheet resistance and offset of the ELG.

Method for providing and utilizing an electronic lapping guide in a magnetic recording transducer

A disk drive is disclosed having a disk, and a head actuated over the disk, the head comprising a magnetoresistive (MR) element. Control circuitry within the disk drive sets an operating bias current for the MR element by computing a target voltage for the MR element, applying a bias current to the MR element, measuring a voltage across the MR element corresponding to the bias current, and adjusting the bias current applied to the MR element until the measured voltage substantially equals the target voltage.

Setting an operating bias current for a magnetoresistive head by computing a target operating voltage

A lapping guide for use in fabrication of a device includes a first resistive element and a second resistive element. The two resistive elements can provide different changing resistances throughout the lapping of the device. These two resistances can be used throughout the lapping of the device to facilitate determination of when a predetermined desired height of the device has been achieved, and therefore stop the lapping of the device. The resistive elements can be physically adjacent to each other or separate from each other. Further, a common lead can be electrically connected to both resistive elements for measuring their respective resistances. In addition, the resistive elements can be separated from each other by the device.

Apparatus and method of device stripe height control

Growing community of inventors

Livermore, CA, United States of America

Curtis V Macchioni