Arvin Meritor Technology, LLC

Meritor Heavy Vehicle Braking Systems (uk) Limited

Corrado Conti

Tomaz Dopico Varela

Steven E Hunter

Fabio Maineri

Brian David Hayes

Paul Roberts

Shan Shih

Marco Bassi

Paul Antony Thomas

Lawrence Doyle Brill

Clive Harrup

Jonathon Leslie Christopher Jackson

Roberto Conti

Gary Ganaway

Paul Hadley

Martin Roche

Alessandro Mortali

Roberti Conti

A caliper for a fixed twin rotor disc brake includes a relatively fixed body, two yokes movable axially with respect to the body, formations defined on the yokes for receiving four brake pads for respective application to rotor sides, and an actuator adapted to urge the yokes relatively axially. One of the yokes is operable to urge two of the four brake pads in a first axial direction, the other of the yokes is operable to urge the other two of the four brake pads in a second, opposite axial direction. The four brake pads are positioned on a first side of the actuator in the first axial direction.

Twin rotor disc brake

An axle system includes an axle shaft offset located within an axle center beam housing. The axle shaft is located in a recess in a top wall of the axle center beam shaped with slopes to maximize clearance to the bottom of the vehicle floor panels. The pneumatic brake cylinders define a cylinder axis angled within an angular range from a generally vertical orientation for enhanced packaging.

Inverted portal axle configuration for a low floor vehicle

A wheel end assembly for a mass transit vehicle includes an output shaft mounted to a wheel hub for driving a vehicle wheel. The output shaft is driven by a gear assembly mounted within a gear housing and operably coupled to an input shaft. The gear assembly includes an input gear driven by the input shaft, a first reduction gear in meshing engagement with the input gear, a second reduction gear operably coupled to the first reduction gear for rotation therewith, and an output gear in meshing engagement with the second reduction gear. The first and second reduction gears are supported on a common shaft that is positioned between the input and output shafts. The input gear and first reduction gear are positioned outboard from the output gear and associated bearings. This double reduction configuration allows vehicle aisle width to be maintained while providing a deeper drop allowing the vehicle floor to be lowered to a position closer to the ground.

Vehicle wheel end assembly with double reduction gear set

Growing community of inventors

Novara, Italy

Corrado Conti