Redlen Technologies, Inc.

Conny Hansson

Krzysztof Iniewski

Elmaddin Guliyev

Glenn Bindley

Robert Crestani

Michael Ayukawa

Jean Marcoux

Saeid Taherion

Georgios Prekas

Michael Rozler

Various aspects include methods of compensating for issues caused by charge sharing between pixels in pixel radiation detectors. Various aspects may include measuring radiation energy spectra with circuitry capable of registering detection events occurring simultaneous or coincident in two or more pixels, adjusting energy measurements of simultaneous-multi-pixel detection events by a charge sharing correction factor, and determining a corrected energy spectrum by adding the adjusted energy measurements of simultaneous-multi-pixel detection events to energy spectra of detection events occurring in single pixels. Adjusting energy measurements of simultaneous-multi-pixel detection events may include multiplying measured energies of simultaneous-multi-pixel detection events by a factor of one plus the charge sharing correction factor.

Charge sharing correction methods for sub-pixellated radiation detector arrays

Various aspects include methods for use in X-ray detectors for adjusting count measurements from pixel detectors within a pixelated detector module to correct for the effects of pileup events that occur when more than one photon is absorbed in a pixel detector during a deadtime of the detector system. In various embodiments, count measurements may be obtained at two different X-ray tube currents, from which the detector system deadtime may be calculated based on the two count measurements and a ratio of the two X-ray tube currents. Using the calculated deadtime, a pileup correction factor may be determined appropriate for the behavior of the detector system in response to pileup events. The pileup correction factor may be applied to pixel detector count values after the counts have been corrected for pixel-to-pixel differences using a flat field correction.

Calibration methods for improving uniformity in X-ray photon counting detectors

Various aspects include methods for compensating for the effects of charge sharing among pixelate detectors in X-ray detectors by applying a correspondence factor to counts of X-ray photons in energy bins to estimate incident X-ray photon energy bins. The correspondence factor may be determined by determining an incident X-ray photon energy spectrum, adjusting the incident X-ray photon energy spectrum to account for an energy resolution of the pixelated detector, generating a charge sharing model for the adjusted incident X-ray photon energy spectrum based on a percentage charge sharing parameter of the pixelated detector, applying the charge sharing model to energy bins of the pixelated detector to estimate counts in each of the energy bins, and determining the correspondence factor by comparing the estimated counts in each of the energy bins to counts in the energy bins that would be expected for the adjusting the incident X-ray photon energy spectrum.

Compensation for charge sharing between detector pixels in a pixilated radiation detector

A set of N standard bin count distributions may be generated by irradiating a test radiation detector system with an X-ray beam attenuated by a respective one of N different K-edge filters for each of the at least one X-ray source energy setting. Energy bins of detectors of a target radiation detector system may be calibrated by generating measured bin count distributions for each calibration setting in which a respective one of the N different K-edge filters attenuates a source X-ray beam. Calibration parameters of the detectors of the target radiation detector system may be adjusted to match each of the measured bin count distributions to a corresponding standard bin count distribution. In addition, energy resolution of the radiation detectors can be measured and calibrated by fitting a portion of the measured X-ray spectrum near a K-edge to a fitting function.

Methods of calibrating semiconductor radiation detectors using K-edge filters

Various aspects include methods and devices for reducing the scanning time for an X-ray diffraction scanner system by increasing the count rate or efficiency of the energy discriminating X-ray detector. In a first embodiment, the count rate of the energy discriminating X-ray detector is increased by increasing the number of detectors counting X-ray scatter photon in particular energy bins by configuring individual pixel detectors within a 2-D X-ray detector array to count photons within specific energy bins. In a second embodiment, the gain of amplifier components in the detector processing circuitry is increased in order to increase the energy resolution of the detector. In a third embodiment, the individual pixel detectors within a 2-D X-ray detector array are configured to count photons within specific energy bins and the gain of amplifier components in the detector processing circuitry is increased in order to increase the energy resolution of the detector.

Growing community of inventors

Victoria, Canada

Conny Hansson