Cisco Technology, Inc.

Cinzia Ferrari

Alberto Arnaldo Tanzi

Stefano Piciaccia

Gianpaolo Barozzi

Optical safety functions are incorporated into protection switching modules which maintain redundant pathways to avoid interruptions in optical network connections. The optical safety functions which lower optical power levels upon interruptions of optical connections are effectively combined with protection switching procedures which are also triggered by interruptions in optical network connections. The interoperation of protection and safety processes keep optical power levels below hazardous levels at system points which might be accessible to human operators.

Optical safety implementation in protection switching modules

An interface between a network component and an optical fiber section communicates with a remote interface and a remote network component at an opposite end of the optical fiber section through over-modulation of optical signals sent between the interfaces and network components. The over-modulation is at frequencies much lower than the ordinary modulation of the optical signals. The over-modulation allows communication between the interfaces for performing management, testing and maintenance operations and permits superior detection of faults in the optical fiber section.

All optical 1+1 protection unit using sub-carrier modulation protocol

Systems and methods for controlling power of WDM channels in a WDM receiver. A preamplifier is provided prior to a demultiplexer in the WDM receiver chain. The gain of the preamplifier may be controlled based on power measurements made on individual WDM channels. A filter with controllable tilt may be employed to compensate for amplifier gain tilt and assure that all of the WDM channels remain within the dynamic range of the photodetector and receiver electronics. This provides improved bit error rate performance.

Growing community of inventors

Parma, Italy

Cinzia Ferrari