Siemens Automotive Corporation

Christoph Kendlbacher

John F Nally, Jr

Wei-Min Ren

John S Bright

Jerry Edward Nines

Michael J Frick

Frank Zimmermann

A method of preheating fuel in a fuel injector with an internal heater energized to reduce emissions. The heater being a ceramic hollow cylinder disposed within a valve body just upstream of a valve seat where fuel is injected through an orifice into the engine. Conductors for energizing the heater extend into the valve body and are sealed against the escape of pressurized fuel. In one version, the conductors are extended through an O-ring to be sealed. In another version the conductors include pins extending through the valve body sidewall with glass seals fused to the valve body and the pins. The conductors may comprise flat foil strips clamped between the O-ring and an elastomeric washer. The conductors also may be molded into the magnetic coil bobbin and sealed where the conductors emerge into the fuel cavity. The heater has metallized surfaces to create current flow through its wall thickness, and the conductors are electrically connected respectively to the inner end and outer surfaces of the hollow cylinder by metallization patterns enabling both mechanical contacts to be made on the outside of the heater.

Method of preheating fuel with an internal heater

A fuel injector has an internal heater energized during cold starting to reduce emissions, the heater being a ceramic hollow cylinder disposed within a valve body just upstream of a valve seat where fuel is injected through an orifice into the engine. Conductors for energizing the heater extend into the valve body and are sealed against the escape of pressurized fuel. In one version, the conductors extend through an O-ring to be sealed. In another version the conductors include pins extending through the valve body sidewall with glass seals fused to the valve body and the pins. The conductors may comprise flat foil strips clamped between the O-ring and an elastomeric washer. The conductors also may be molded into the magnetic coil bobbin and sealed where the conductors emerge into the fuel cavity. The heater has metallized surfaces to create current flow through its wall thickness, and the conductors are electrically connected respectively to the inner end and outer surfaces of the hollow cylinder by metallization patterns enabling both mechanical contacts on the outside of the heater.

Fuel injector with internal heater

Growing community of inventors

Vienna, Austria

Christoph Kendlbacher