Hughes Aircraft Company

Cheng-Keng Pao

Cheng P Wen

William E Stanchina

David B Rensch

Chan-Shin Wu

A multi-layer collector heterojunction transistor (10) provides for high power, high efficiency transistor amplifier operation, especially in the RF (radio frequency) range of operation. A larger band gap first collector layer (12), approximately 15% of the active collector region (11) thickness, is provided at the base-collector junction (13). A smaller band gap second collector layer (14) forms the remainder of the active collector region (11). The multi-layer collector structure provides higher reverse bias breakdown voltage and higher carrier mobility during relevant portions of the output signal swing. A lower saturation voltage limit, or 'knee' voltage, is provided at the operating points where linear operating regions transition to saturation operating regions as depicted in the output voltage-current (I-V) characteristic curves. The magnitude of the output signal swing of an amplifier may be increased, providing higher power amplification with greater power efficiency. The power supply voltage for the amplifier may be increased, providing for the use of a smaller, lighter power supply.

Multi-layer collector heterojunction transistor

A relatively high power active gain device, such as MESFET or similar transistor, has distributed impedance characteristics at relatively high RF (microwave) frequencies of operation due to physical device size limitations. A transmission line segment (104) is placed in relatively close spacial relationship and is coupled in parallel electrical relationship with the input port (162) of the high power active device. This provides for highly simplified design of an impedance prematched amplifier (100) over a relatively broad range of predetermined input signal center frequencies. An active device (102) is provided based on power requirements and is characterized over a range of center frequencies and device sizes independently from the characterization of the transmission line segment (104) over a range of center frequencies and segment lengths, since the impedance characteristics of the active device (102) and the transmission line (104) are not dependent upon each other. Based on a predetermined operating center frequency and on the input source impedance characteristics, an appropriate pre-characterized transmission line segment (104) is paired with an appropriate pre-characterized active device (102) based on a simplified model for the prematched amplifier (100). Characterization procedures are therefore simplified and relatively inexpensive. The design cycle for a prematched amplifier is considerably simplified, shortened, and reduced in cost.

Growing community of inventors

Torrance, CA, United States of America

Cheng-Keng Pao