Bear Medical Systems, Inc.

Charles W Cutler

A system for measuring the flow rate of gas includes a flow head having a sensor thermoresistor mounted transversely to the flow of gas, and a reference thermoresistor mounted parallel to the flow of gas, both thermoresistors having equal resistance versus temperature functions. Each thermoresistor is connected in a feedback control circuit, in which each thermoresistor is separately supplied with current to heat it, the current first passing through a fixed resistance in series with each of the thermoresistors. The current supplies are servo controlled to equalize the resistance of each thermoresistor with that of its associated fixed resistance. The power consumed by each thermoresistor at its equilibrium resistance is measured to provide a power indicative signal associated with each thermoresistor. The two power indicative signals are compared to generate a delta power signal. An empirically-derived flow rate-versus-delta power curve is stored as a look-up table in a computer memory. The value of the delta power signal is applied to address the look-up table to acquire the corresponding flow rate value.

Flow sensor system

A gas flow sensor system, using hot wire flow and temperature sensors, compensates and corrects for various factors, such as water vapor content and gas composition in the measured gas, gas temperature, physical differences in the sensors, ambient atmospheric pressure, and nonlinearities in the system. Physical differences in the sensors are corrected by adjusting the magnitude of the constant current flowing to the temperature sensor. Water vapor content and gas temperature corrections are made by modifying a flow temperature signal based on the resistance of the temperature sensor to form a flow reference signal indicative of a desired resistance difference between the resistances of the temperature and flow sensors, which resistance difference varies with the flow temperature signal. The flow reference signal is compared to a flow resistance signal (indicative of the resistance of the flow sensor) and the resulting flow correction signal is used to control the current flow to the flow sensor. A flow output signal based on the current flow to the flow sensor provides an indication of flow rate. This flow output signal can then be corrected for the composition of the gas being measured. This composition corrected output can then be further corrected for nonlinearities in the system by use of a look-up table. This further corrected output signal can then be still further corrected for such factors as ambient pressure and standard temperature.

Growing community of inventors

San Bernardino, CA, United States of America

Charles W Cutler