Pericom Semiconductor Corporation

Charles Hsiao

David Kwong

Anthony Yap Wong

Michael B Cheng

Belle Wong

Lee Yang

A synchronizer that has reduced latency is used for synchronizing and conditioning a clock-enable signal to a free-running clock. Once the clock-enable signal is synchronized it is used to enable and disable gating of the free-running clock to a gated clock that suspends pulsing in response to the clock-enable signal. A first-stage flip-flop is `meta-stable hardened` to reduce the probability of it becoming meta-stable. Gating on the clock and the clear inputs reduces the chance that simultaneous inputs will violate the timing of the flip-flop and thus cause metastability. A clear pulse is generated to clear the flip-flop. The clear pulse skews the flip-flop to be more likely to become metastable for one edge of the asynchronous input than for the other edge. The settling time to the second stage flip-flop is then adjusted to account for this skew in metastability. Settling time in the second stage is increased for the edge that is more likely to become metastable. Clock-enable conditioning to prevent partial output pulses is merged with the synchronizing function to further reduce latency.

Meta-stable-resistant front-end to a synchronizer with asynchronous

A substrate bias generator for an integrated circuit has a charge pump driven by an oscillator. The oscillator is enabled and disabled to save power and control the voltage-level itself for the substrate bias. An enabling circuit senses the substrate voltage and enables the oscillator when the substrate voltage rises above a bias set by a programmable reference voltage. The enabling circuit which senses the voltage on the substrate draws no active current from the substrate. The sensing circuit includes a transistor with only its bulk terminal connected to the substrate; the source, gate, and drain of this sensing transistor are not connected to the substrate. A differential comparator compares the output of the sensing transistor to the programmable reference voltage and enables the oscillator when the sensing transistor output is lower than the reference voltage. The sensing transistor attenuates large swings in the substrate voltage to provide the differential comparator with a small voltage swing which keeps the differential comparator operating near its optimum design point. Since no active current is drawn from the substrate when sensing the substrate voltage, no IR voltage drops can develop from the enabling and sensing circuit. Thus latch-up immunity is improved and substrate noise is reduced.

Programmable substrate bias generator with current-mirrored differential

An all-CMOS output buffer drives a bus that can operate at 3 volts and 5 volts. When in a high-impedance state, the output buffer draws little or no current. If the bus is driven to 5 volts by an external device, the high impedance output buffer is in danger of latch-up and distortion of the bus logic level since it only has a 3-volt power supply and does not use a charge pump or an extra 5-volt supply. A biasing circuit couples an N-well that contains p-channel transistors and a driver transistor to the bus driven to 5 volts. Thus the N-well is also driven to 5 volts, the voltage on the bus. The gate of the p-channel driver transistor in the high-impedance output buffer is also coupled to the N-well by another p-channel transistor, raising the gate potential to 5 volts. Thus the gate and body of the p-channel driver transistor is at 5 volts, eliminating reversing current and latch-up problems. A transmission gate isolates the gate of the p-channel driver transistor from the rest of the device's circuitry. The p-channel transistors of the transmission gate, bias circuitry, and driver transistor are located in the N-well, which is biased up to 5 volts only when necessary. Thus during normal operation, the N-well of the driver transistor is at 3 volts, eliminating a performance loss from the body effect. A logic gate increases the well bias and isolates the driver's gate only when necessary, when the bus is high and driven by a 5-volt device, and the output buffer is in high-impedance.

Growing community of inventors

Fremont, CA, United States of America

Charles Hsiao