Framatome Anp Gmbh

Chad Evans Gill

Mark Alan Klahn

A tube testing system consists of two subassemblies, the probe and the applicator. The probe uses a stack of Belleville style washers that when compressed allow the locking fingers to relax and the probe to be inserted into the tube. Once the probe is placed in the correct location using the applicator, the Belleville style washers are allowed to expand, locking in the fingers and engaging the urethane seals. As the water fills the tube, the air is pushed through a bleed hole in the mandrel of the probe. The bleed hole leads to a chamber in the top of the probe that contains a plastic ball. The ball floats on water and as the chamber fills, the ball seals off the leak path and the tube can then be pressurized and the test performed. Once the test is complete, the water is drained and using the applicator, the probe is removed from the tube.

Method of testing boiler tube integrity and probe for same

An in-situ testing apparatus for testing the integrity of rib plugs used to seal faulty reactor boiler tubes consists of a cup-shaped member with a groove on the open end, a tapped hole for attaching a hydraulic hose of known pressure, and a hole through the top of the member. A seal is installed in the groove on the open end of the cup to seal to the primary face of a tubesheet around the tested rib plug. A threaded mandrel goes through the hole in the top of the cup-shaped member and engages the expander member of the rib plug. The threading action of the mandrel into the expander draws the seal against the tubesheet to seal the testing apparatus and allows the rib plug to be in-situ pressure tested.

Growing community of inventors

Lynchburg, VA, United States of America

Chad Evans Gill