Vecima Networks Inc.

Brian Berscheid

Ha Hoang Nguyen

Eric Salt

Tung Trong Nguyen

Joseph Eric Salt

Quang Nguyen

Aroutchelvame Mayilavelane

Zohreh Andalibi

Ha H Nguyen

In embodiments of the presently described subject matter, two efficient PAPR reduction methods for OFDM signals based upon the principle of tone reservation and building upon the clipping noise analysis presented in 'Analysis of clipping noise and tone reservation algorithms for peak reduction in OFDM systems,' L. Wang and C. Tellambura,., vol. 57, pp. 1675-1694, May 2008 are provided, each comprising two stages. The first stage is performed offline to prepare a set of cancellation signals based on the settings of the OFDM system. In particular, these cancellation signals are constructed to cancel signals at different levels of maximum instantaneous power that are above a predefined threshold. The second stage is performed online and in an iterative manner to reduce the peaks of OFDM symbols by using the cancellation signals constructed in the first stage.

Papr reduction for OFDM signals

In a digital communication system there is provided a method for OFDM channel estimation that jointly considers the effects of coarse timing error and multipath propagation. The method uses an iterative channel estimation technique, which considers the practical scenario of fractional timing error and non-sample space echo delays. The method does not require channel state information such as second-order statistic of the channel impulse responses or the noise power. Moreover, timing error can be conveniently obtained with the proposed technique. Simulation shows that, when comparing OFDM channel estimation techniques under DOCSIS 3.1 realistic channel conditions, the proposed algorithm significantly outperforms conventional methods.

Estimating the frequency response of multipath channels

Data samples are filtered by using a digital filter where the length of an impulse response of the digital filter is finite, an impulse response of the digital filter is symmetric and the operation of the digital filter is multi-rate. The method uses a polyphase decomposition to break down the input data stream into N parallel substreams and the multi-rate digital filter is separated by a polyphase decomposition into multiple lower-rate sub-filters where each of the sub-filters is separated into a set of simpler sub-sub-filters which operate upon the same set of input samples and which have impulse responses which are jointly centro-symmetric, a set of pre-filtering arithmetic structures, and a set of post-filtering arithmetic structures and performing each such pair of sub-sub-filtering operations using a single shared filter structure, a set of pre-filtering combining adders, and a set of post-filtering separating adders.

Fast FIR filtering technique for multirate filters

Method of estimating the frequency response of multipath channels

In a DOCSIS transmission network, it is necessary for an upstream receiver to estimate and correct for errors in the carrier frequency of the transmission based upon observations of a preamble sequence. This task is complicated by the fact that microreflections in the upstream channels cause intersymbol interference, which tends to bias the frequency estimation circuit. An economical, ISI-immune algorithm is provided for estimating the carrier frequency of upstream transmissions. The arrangement improves the reliability of the frequency estimates in the presence of ISI, thereby reducing the overhead and increasing the throughput of the upstream channels.

Frequency offset estimator for upstream cable signals

In an RF signal transmission network such as the reverse channels of a coaxial cable network, there is provided at least one adaptive equalizer for pre- or post-filtering inter-symbol interference in the transmitted signals, the adaptive equalizer having a series of coefficients for which values are required. In order to improve the transmission efficiency the preamble used in these channels is shortened by coarsely estimating the channel using a short 'unique word' placed at the beginning of the equalizer training sequence. The coarse channel estimate is crudely inverted to produce a set of equalizer coefficients which partially equalize the channel. By initializing the adaptive equalizer with these approximate coefficients, it is possible to reduce the length of the training sequence needed for the equalizer to converge.

Growing community of inventors

Saskatoon, Canada

Brian Berscheid