Northern Telecom Limited

Brian A Sutherland

Stanley D Rosenbaum

Reinhard W Rosch

Paul Fong-Yan Hung

Donald S McGinn

Francois Y Tremblay

Joseph F Darveau

Brian Glenn Wall

Alan William Jaakkola

A power converter forming part of a telephone subscriber line interface circuit selectively generates a ringing signal waveform, for supply to the line, or a supply voltage for a driver circuit for providing loop current on the line. First and second fixed frequency PWM signals are used to control the power converter, and hence the voltage which it generates, for the ringing signal waveform and the supply voltage respectively. The first PWM signal enables the power converter to provide a high power level needed for ringing signals. The second PWM signal has a lower frequency, and hence results in lower switching losses and power dissipation, and a lower duty cycle, suitable for the lower power level needed for the supply voltage, and is conveniently produced by masking pulses of the first PWM signal. The frequency of the second PWM signal is greater than 270 kHz, to avoid transmitting spectral energy to the line below this frequency.

Switchmode power converters for telephone subscriber line interface

A telephone line interface circuit comprises a controlled voltage generator for selectively generating a ringing voltage waveform for a telephone line or a supply voltage for a drive circuit for the telephone line, and a switching circuit interconnecting an output of the controlled voltage generator, the drive circuit, and the telephone line accordingly. In order to avoid creating a potentially hazardous condition on the telephone line, an interlock is provided between enabling of the controlled voltage generator and switching of the switching circuit, and software and hardware monitoring functions monitor operation of the control software and the controlled voltage generator and disable the controlled voltage generator in response to fault conditions or unusual behavior.

Hazard prevention for telephone line interface circuits

An automatic protection and recovery method for a telephone line interface circuit is described. The interface circuit monitors current on the line, and in the event of a fault producing an excessive current a protection relay interrupts a connection of the interface circuit to the line, and the interface circuit monitors common mode voltage on the line. The interface circuit is reconnected in response to the monitored voltage being below a relatively high threshold. If a second interruption results, the interface circuit is then reconnected in response to the monitored voltage being below a lower threshold. If a further interruption results, the interface circuit enters a ground fault recovery process. The method facilitates protection and rapid recovery from arbitrary fault conditions on the telephone line.

Protection and recovery of telephone line interface circuits

A two-wire telephone line interface circuit comprises a driver circuit for supplying direct current on the line, a controlled voltage generator, a sensing circuit for monitoring the line current, a control circuit for controlling an output voltage of the voltage generator, and a switching circuit. The control circuit controls the switching circuit to supply, as a supply voltage for the driver circuit, a battery voltage in an on-hook state of the line or the controlled output voltage of the voltage generator in an off-hook state of the line, this output voltage being controlled to provide off-hook current limiting. The control circuit also controls the switching circuit to selectively supply the controlled output voltage of the voltage generator as a signalling voltage to at least one wire of the line for high voltage signalling, e.g. ringing, on the line. Desirable forms of the switching circuit are described.

Telephone line interface circuit with voltage switching

High voltage converters are disclosed. The converters include at least a pair of transistor switches provided on the secondary windings of a flyback transformer. The transistor switches are controlled to be conducting, variably conducting and non-conducting so that the power flow between the transformer and a load can be controlled. Various configurations of a connection switch network are also disclosed.

Growing community of inventors

Kanata, Canada

Brian A Sutherland