Siemens Aktiengesellschaft

Axel Müller

Ulrich Emmerling

Antonio Romero-Lobato

The system has a uniform system architecture that is designed for an access authorization request both with and without the use of a transponder. Should a transponder be used, only a corresponding transponder must be fitted in the key that can interact with an immobilizer coil specially provided for this in a receiving unit of the motor vehicle. In this case, the corresponding system requirements have also already been taken into consideration in the system architecture. As a result, the different system requirements for access and right of use systems to a great extent provide flexibility.

Access authorization and right of use system, of a motor vehicle

A low-cost, wide input range, DC-DC voltage-switching converter regulator device for supplying power to various components in an automotive application includes two pairs of serialized switch elements for controlling separate Boost and Buck Modes each through a respective one of said pairs. In particular, the converter regulator device is arranged for under control of a driving voltage below a first threshold voltage outputting a negligible output current, in a Buck-Mode under control of a driving voltage above a second threshold voltage outputting a Buck-Mode flat current level through alternating and mutually opposing conducting states of the first switch elements, and in a Boost-Mode under control of a driving voltage between the first and second thresholds outputting a Boost-Mode flat current level that is substantially lower than the Buck-Mode current level through driving via the inductor a medial tap of serialized second switch elements of which one terminal tap constitutes an output terminal of the converter.

Wide input range buck/boost switching regulator

In a method for operating an electronic anti-theft system, data communication is effected between the control device and the key further to an access authorization request, whereby the control device unlocks the doors and deactivates an alarm system as a function of the data communication. The data communication for unlocking the doors and the data communication for disarming the alarm system are separate from each other. In this way, the mechanical unlocking of the doors can be initiated immediately after the data communication for unlocking the doors. The corresponding data communication for deactivating the alarm system is effected in parallel with this, whereby extensive cryptological data is exchanged between the control device and the key.

Electronic anti-theft system

In the device a controllable switch is built into the control device which enables the start authorization and by means of which the supply voltage with which this controllable switch is supplied can be switched off. To check a start authorization a diagnosis can be undertaken which is realized with known resistance elements in the voltage supply line between identification device holder and control device. This allows the voltage drops across the elements to be compared with the corresponding required values. Simple short circuiting of the starter or the ignition is thus no longer possible since this would be detected by the control device as a result of the changes in voltage drop. In addition a fault in the supply voltage or the feed lines can be definitively detected.

Growing community of inventors

Wuppertal, Germany

Axel Müller