Continental Automotive Gmbh

Continental Automotive France

Audi Ag

Vitesco Technologies Gmbh

Aurélien Groussard

Thierry Collet

Oliver Grunwald

Benoit Ejarque

A method for checking a measurement of pressure in a fuel tank, implemented in a vehicle having a fuel tank and a fuel vapor breather circuit including: a filter, a tank isolation valve interposed between the tank and the filter, and a purge line, connected to the filter, downstream thereof, a pressure sensor, and a purge valve. The method includes, when the purge valve is closed: measuring a value of the pressure in the tank when the isolation valve is closed, then measuring a temporal extreme value for the pressure in the purge line following an opening of the isolation valve, and determining, from the measured values, that there is an anomaly in the measured pressure in the tank.

Method for checking a pressure measurement in a fuel tank

Disclosed is a method for controlling depressurization in a fuel tank of a motor vehicle, including: the initial controlled opening of the isolation valve in order to lower the pressure inside the tank; determination of a blockage condition in the roll over valve on the basis of at least one item of information relating to the pressure gradient in the tank following the initial opening of the isolation valve; and, if the roll over valve blockage condition is met, the controlled closing of the isolation valve, followed by its controlled re-opening in order to continue lowering the pressure in the tank.

Method for controlling depressurisation in a motor vehicle fuel tank

Disclosed is a method for monitoring pressure, for a vessel assembly including a sealed vessel capable of holding a liquid, a filter capable of capturing vapors from the liquid, a pipe connecting the vessel to the filter, and an isolation valve arranged to selectively shut off the pipe, including a detection of the boiling of the liquid contained in the vessel.

Method for monitoring pressure including boil detection

Disclosed is a method for controlling the pressure inside a fuel tank of a motor vehicle, the motor vehicle including a fuel vapor vent circuit connecting the tank to a fuel vapor canister, the vent circuit including an isolation valve for isolating the tank and a rollover valve. The pressure control method includes steps of: determining an activation duration required for the isolation valve to transition from a closed state to a fully open state, referred to as the 'full opening duration', when a predefined rollover valve closure risk criterion is satisfied: controlling the isolation valve in repeated activations of respective durations that are shorter than the full opening duration.

Growing community of inventors

Toulouse, France

Aurélien Groussard