Com Dev Limited

Antonio Romano

A telemetry system with a matrixed telemetry switch unit array and a method for determining the switch position of a telemetry switch unit. The switch units include steering diodes and parallel signal paths each with unique resistance values. The signal paths correspond to switch positions and are closed when the switch unit is in the corresponding switch position. A signal source is electrically connected to an input current path and output current path of the array with a corresponding telemetry switch unit coupled into the signal path. A plurality of sensing signals are applied through the array and the resultant signals are measured. The switch position is determined from the resultant signals indicating the resistance value of the switch signal path currently coupled into the array signal path while accounting for the voltage drop of the steering diodes.

Resistive telemetry system and method

A fully monolithic cross-point switch matrix overcomes the isolation problems between unconnected ports of the prior art. An Isolation Enhancement Network (IEN) is connected between each of the input and output transmission lines at each of the cross-points. The switch matrix is comprised of a tiled interconnection of M&times;N of the 1&times;1 switch/IEN (SIEN) cells, where N and M are the number of input and output ports respectively. Each of the SIEN cells can be independently configured into one of two operating modes, connected or unconnected. The switching element is configured to provide a high isolation path between the input and output lines in the unconnected mode of operation. In this case, a small fraction of the input signal injected at the input port appears at the output port. This output signal is comprised of two components. The first component arises from a number of stray coupling mechanisms between the input and output lines but does not include the portion of the input signal which passes through the IEN. The dominant area of this stray coupling occurs at the point where the input and output transmission lines cross. The second component of the output signal is purposely injected via the IEN. The IEN couples a small portion of the input signal, adjust its amplitude and phase, and then recouples it to the output line so that the resultant signal has the same amplitude but is 180 degrees out-of-phase with the first component. The two components cancel each other yielding an improvement in the isolation between the two ports. The compensation signal injected by the IEN into the output line is significantly lower than the main signal component when the switching element is in the connected state, thereby allowing the input signal to be routed to the output with insignificant perturbation.

Growing community of inventors

Cambridge, Canada

Antonio Romano