Freescale Semiconductor,inc.

Ankit Pal

Girraj K Agrawal

Asif Iqbal

Amrit Pal Singh

Akshat Mittal

Amit Aggarwal

Himanshu Goel

Ruchika Gupta

Ashish Malhotra

Prabhakar Kushwaha

Poonam Aggrwal

Priti Sahu

Aneesh Bansal

Kalyana E S Chakravarthy

A fail-safe booting system suitable for a system-on-chip (SOC) automatically detects and rectifies failures in power-on reset (POR) configuration or boot loader fetch operations. If a failure due to a boot loader fetch occurs, a POR configuration and boot loader are fetched from a different non-volatile memory. The reloading takes place from further different non-volatile memory sources if the boot loader fetch fails again. The automated system operates in accordance with a state machine, and does not involve any manual, on-board switch selection or manual re-programming.

Method and apparatus for booting processor

A processing system has a stored, encrypted data structure that is decrypted to provide verification data values. System data values are retrieved from locations distributed about a memory storing system data. The verification data values are compared with corresponding system data values to determine if a predetermined threshold of verification data values matches the system data values. The system resumes operation if the predetermined threshold is met.

Secure boot on deep sleep wake-up

An integrated circuit (IC) includes multiple circuit modules that have specific clocking requirements, multiple clock sources (e.g., PLLs, duty cycle re-shaper, etc.), and at least one clock input port. The clock sources have specific clock source specifications, and the circuit modules have specific clocking requirements. The clock sources are selected based on an identification of the most common clocking requirements, and then placed at routing distances measured from the input port that are less than corresponding predetermined maximum routing distances such that the clocking requirements of the circuit modules are met. The IC thus generates clock signals internally, rather than externally.

Clock distribution architecture for integrated circuit

A channel equalizer that compensates for signal distortion of a signal in a communication channel includes an equalization filter, which gain-equalizes a received signal received through the communication channel, and an equalization control circuit, which generates a gain control signal for controlling the gain of the equalization filter. The equalization control circuit specifies a phase switch in data obtained by the equalization filter as an isolated bit and generates the gain control signal based on a width of the isolated bit.

Digital adaptive channel equalizer

An input bit stream including a clock signal and data bits is oversampled to obtain one or more sets of data samples. One or more sets of non-transitioning phases corresponding to data samples that do not switch between zero and one are then identified. Center phases corresponding to the one or more sets of non-transitioning phases are identified and then a final center phase that accurately represents the bits belonging to the input bit stream is selected. The data samples corresponding to the final center phase are extracted, thereby recovering the clock signal and data bits from the input bit stream.

Method for clock and data recovery

An input bit stream is received and zone statistics such as zones count, zones center bit positions, and zones lengths are determined, where a zone is a set of non-transitioning bits in the input bit stream. Beginning and ending bit positions for each zone are determined simultaneously, and each beginning bit position is associated with an ending bit position. Zone statistics are calculated using the determined beginning and appropriate ending bit positions.

Method and system for determining bit stream zone statistics

A bit stream is received and each bit corresponding to the bit stream is over-sampled to generate a first set of data samples. Each data sample from the first set of data samples is compared with a corresponding immediate previous data sample to generate a second set of data samples. The second set of data samples is compared with bit masks, and accordingly, some of the data samples in the first set of data samples are identified for replacement. Further, a substitute data sample is selected from the first set of data samples based on a predefined criterion and some of the data samples in the first set of data samples are replaced with the substitute data sample.

Growing community of inventors

Ghaziabad, India

Ankit Pal