Maxlinear, Inc.

Andy Lo

Sugbong Kang

Curtis Ling

Tete Sedalo

An impulse noise mitigation circuit (INMC) may set a cut-off frequency of each of two high pass filters to bound a frequency bandwidth of a desired signal, wherein a first of the two filters allows frequencies higher than the frequency bandwidth of the desired signal, and a second of the two filters allows frequencies lower than the frequency bandwidth of the desired signal. The INMC may compute and store a mean magnitude separately for a first signal response of the first filter and a second signal response of the second filter. The INMC may select the first filter for impulse noise mitigation when the mean magnitude of the second filter is greater than the mean magnitude of the first filter. The INMC may select the second filter for impulse noise mitigation when the mean magnitude of the first filter is greater than the second filter.

Impulse noise mitigation under out-of-band interference conditions

A wireless communication receiver includes a multitude of look-up tables each storing a multitude of DC offset values associated with the gains of an amplification stage disposed in the wireless communication receiver. The entries for each look-up table are estimated during a stage of the calibration phase. During such a calibration stage, for each selected gain of an amplification stage, a search logic estimates a current DC offset number and compares it to a previous DC offset estimate that is fed back to the search logic. If the difference between the current and previous estimates is less than a predefined threshold value, the current estimate is treated as being associated with the DC offset of the selected gain of the amplification stage and is stored in the look-up table. This process is repeated for each selected gain of each amplification stage of interest until the look-up tables are populated.

Method and apparatus for efficient DC calibration in a direct-conversion system with variable DC gain

A noise abatement method and system for impulse noise in an RF receiver where the RF analog signal is converted to a digital signal prior to being connected to a demodulator. Two filters are used to detect impulse noise signals even under out-of-band interferer conditions, and prevent the impulse noise from reaching the input to the demodulator. A first of the two filters detects impulse noise using signals lower than the frequency bandwidth of the desired signal, and a second of the two filters detects impulse noise using signals higher the frequency bandwidth of the desired signal. A mean magnitude of the signal is detected over a predetermined time T and is used to select which filter to use for noise abatement.

Growing community of inventors

San Diego, CA, United States of America

Andy Lo