Vision-ease Lens, Inc.

Hutchinson Technology Corporation

Insight Equity A.p.x., L.p.

Alan D Maki

Thomas J Moravec

Martin L Hage

Edward A Travnicek

Eric J Woelfle

Darrell B Kroulik

Michael Wayne Davis

Mark G Lowry

Mohammed Kazemi

Jeffrey L VerMurlen

David C Olund

A disk drive head suspension including a load beam having a load beam load point region and a flexure, attached to the load beam, having a flexure load point region. A mass of viscoelastic material is fixedly attached to both load beam load point region and flexure load point region to form a pinned load point. A method for manufacturing a disk drive head suspension of the type having a flexure with a flexure load point region on a load beam with a load beam load point region. The flexure load point region is spaced apart from the load beam load point region. A load point is formed by applying a mass of viscoelastic material to the load point region of at least one of the flexure and the load beam.

Head suspension having viscoelastic load point

A flat or curved photochromic laminate structure and a plastic photochromic lens blank can be produced in a simple and efficient manner from relatively low-cost polymeric sheet materials. These laminates can be used to provide goggles, face shields, windows, window coverings, skylights, and optical lenses having efficient, uniform and high quality photochromic properties. The use of a polyesterurethane as the binder for the photochromic material has been found to improve the performance of the photochromic material. There may be a desire to have a protective exterior layer (e.g., an abrasion resistant layer) in combination with the lens system, but that may be provided in various methods. In the case of using the laminate in a goggle application, the laminate may be hard coated on one or both outer surfaces with an abrasion resistant coating, antireflective coating, and/or an anti-fog hard coating.

Injection molding of lens

Multifocal ophthalmic lenses may be manufactured by either injection molding and casting methodologies. The use of two opposed tools (mold faces) with relatively centered faces, but with significantly differing diameters can be used to provide multifocal ophthalmic lenses. The process is surprisingly capable of providing multifocal lenses with good control of the thickness of the lenses, with relatively thin center thicknesses (e.g., less than 4.7 mm, or less than 3.5 mm) and relatively thin edge thicknesses (e.g., 0.5 to 2.5 or to 2.0 mm). The tool faces (the molds for the front and rear surfaces) may be readily replaced within the mold to enable manufacture of a wide range of lens prescriptions with minimum down time.

Manufacturing of positive power ophthalmic lenses

Growing community of inventors

Chaska, MN, United States of America

Alan D Maki